Search results
Results From The WOW.Com Content Network
The most famous American passenger car application of the torsion bar, was the Chrysler system used beginning with all Chrysler products starting with the 1957 model year in cars such as the Imperial Crown series, Chrysler Windsor, DeSoto Firedome, Dodge Coronet and Plymouth Belevedere although Chrysler's "Torsion-Air" suspension was only for ...
The predecessor of modern electronic traction control systems can be found in high-torque, high-power rear-wheel-drive cars as a limited slip differential.A limited-slip differential is a purely mechanical system that transfers a relatively small amount of power to the non-slipping wheel, while still allowing some wheel spin to occur.
In 1920, Leyland Motors used torsion bars in a suspension system. In 1922, independent front suspension was pioneered on Lancia Lambda, and became more common in mass market cars from 1932. [8] Today, most cars have independent suspension on all four wheels. The part on which pre-1950 springs were supported is called a dumb iron.
A Panhard rod (also called Panhard bar, track bar, or track rod) is a suspension link that provides lateral location of the axle. [1] Originally invented by the Panhard automobile company of France in the early twentieth century, this device has been widely used ever since.
The essential problem is keeping the differential from rotating during acceleration and braking. The torque tube solves that problem by coupling the differential housing to the transmission housing and, therefore, propels the car forward by pushing up on the engine/transmission and then through the engine mounts to the car frame, with the ...
The Hillman Imp designers learned from the problems with the Corvair, having crashed [4] one at a relatively low speed, and they designed their rear-engined car with a semi-trailing arm suspension at the rear. To attain correct handling balance, they actually used swing-axle geometry at the front, with the steering pivots mounted at the outer ...
The front of the H attaches to the body via rubber bushings, and the rear of the H carries each stub-axle assembly, on each side of the car. The cross beam of the H holds the two trailing arms together, and provides the roll stiffness of the suspension, by twisting as the two trailing arms move vertically, relative to each other.
Traction can also refer to the maximum tractive force between a body and a surface, as limited by available friction; when this is the case, traction is often expressed as the ratio of the maximum tractive force to the normal force and is termed the coefficient of traction (similar to coefficient of friction).