Ad
related to: 1.778 m to inches
Search results
Results From The WOW.Com Content Network
Keen, whom Hilda was planning to use as a dressage mount in the 1984 Olympics, was a chestnut gelding, 17.2 hands high (5 feet 10 inches, 1.778 meters), and a large, beautiful, dark gelding who was 18 in 1984. Hilda noted that training a horse for dressage was very difficult but very rewarding, despite the complexity and challenge of ...
The playing area of a standard tournament table measures 11 feet 8 inches by 5 ft 10 in (3.569 m by 1.778 m) with a tolerance of 1 ⁄ 2 inch (1.26 cm) in both directions, though smaller ones, down to half size, are often found in snooker halls, pubs and home billiard rooms.
Note: 48-foot and 53-foot units can only be stacked in a 40-foot compliant stack if they are just 8 feet wide, or have special structural provisions to handle their usual 6 inch (15.2 cm) extra width.
A 12-gauge shotgun, nominally 18.5 mm (0.73 in), can range from a tight 18 mm (0.71 in) to an extreme overbore of 20 mm (0.79 in). Some also claim an increased velocity with the overbored barrels, up to 15 m/s (49 ft/s), which is due to the larger swept volume of the overbored barrel.
The latest Los Angeles County wildfire, dubbed the Hughes Fire, began as a brush fire Wednesday a little before 11 a.m. before spreading to over 8,000 acres by around 4 p.m. local time.
Illinois Central 2613 was a 4-8-2 "Mountain" type 2600 class steam locomotive built in April 1943 by the Illinois Central Railroad's Paducah Shops in Paducah, Kentucky.No. 2613 and its classmates were the most powerful 4-8-2 locomotives ever built.
It measured 12 feet 6.75 inches (3.83 m) by 5 feet 7 inches (1.70 m), and since the wagon was only 10 feet (3.0 m) by 7 feet 6 inches (2.29 m), it must have overhung the wagon when being carried. The casting fell from the wagon onto the rails when the train was about 3 ⁄ 4 mile (1.2 km) from Howden station.
ANSI B94.11M-1979 sets size standards for jobber-length straight-shank twist drill bits from 1/64 inch through 1 inch in 1/64 inch increments. For Morse taper -shank drill bits, the standard continues in 1/64 inch increments up to 1¾ inch, then 1/32 inch increments up to 2¼ inch, 1/16 inch increments up to 3 inches, 1/8 inch increments up to ...