Search results
Results From The WOW.Com Content Network
The Ford EEC (Electronic Engine Control) system, which utilized the Toshiba TLCS-12 microprocessor, went into mass production in 1975. [ 7 ] The first Bosch engine management system was the Motronic 1.0 , which was introduced in the 1979 BMW 7 Series (E23) [ 8 ] This system was based on the existing Bosch Jetronic fuel injection system, to ...
The CEC also controlled ignition timing using information from the fuel-control section and an engine knock sensor on the intake manifold. The CEC module itself (the most common version of which is the "AMC MCU Super-D") was manufactured for AMC by Ford Motor Company, and worked with a Duraspark ignition system. Although built by Ford, the CEC ...
The feedstock to the FCC conversion process usually is heavy gas oil (HGO), which is that portion of the petroleum (crude oil) that has an initial boiling-point temperature of 340 °C (644 °F) or higher, at atmospheric pressure, and that has an average molecular weight that ranges from about 200 to 600 or higher; heavy gas oil also is known as ...
The manifold absolute pressure sensor (MAP sensor) is one of the sensors used in an internal combustion engine's electronic control system. Engines that use a MAP sensor are typically fuel injected. The manifold absolute pressure sensor provides instantaneous manifold pressure information to the engine's electronic control unit (ECU).
The Ford EEC or Electronic Engine Control is a series of ECU (or Engine Control Unit) that was designed and built by Ford Motor Company. The first system, EEC I, used processors and components developed by Toshiba in 1973. It began production in 1974, and went into mass production in 1975. It subsequently went through several model iterations.
Diesel exhaust fluid (DEF; also known as AUS 32 and sometimes marketed as AdBlue [3]) is a liquid used to reduce the amount of air pollution created by a diesel engine. Specifically, DEF is an aqueous urea solution made with 32.5% urea and 67.5% deionized water .
Electronic engine control (EEC): An EEC is essentially a hydromechanical fuel control but with added electrical components to prevent overheating or overspeeding the engine. If the electrical part of the control should fail, an EEC will revert to a standard hydromechanical fuel control. Full-authority digital engine control (FADEC): A digital ...
These blow-by gases, if not ventilated, inevitably condense and combine with the oil vapor present in the crankcase, forming oil sludge. Excessive crankcase pressure can furthermore lead to engine oil leaks past the crankshaft seals and other engine seals and gaskets. Therefore, it becomes imperative that a crankcase ventilation system be used.