Ad
related to: configuring multicast on cisco switches for sale in sri lanka today
Search results
Results From The WOW.Com Content Network
[2] [3] [4] Regarding IP multicast, it is a technique for one-to-many communication over an IP network. IP multicast covers some part of common multicast routing protocol. IP multicast also describe IP multicast software (i.e. VideoLAN,qpimd – PIM Daemon for Quagga, GNU — PIM module for the Quagga Routing Suite, UFTP, etc.).
The Cisco Supervisor Engine serves as the management card for modular Cisco switches that can also, in some cases, act as forwarding/routing element. [1]Over time, the Supervisor Engine has undergone multiple iterations and was different for different modular switches in Cisco Portfolio (Catalyst 4000, 4500, 5000, 5500, 6000, 6500, 9400, 9600 and Nexus switches).
MVRP, which replaced GVRP, is a standards-based Layer 2 network protocol, for automatic configuration of VLAN information on switches. It was defined in the 802.1ak amendment to 802.1Q-2005. Within a layer 2 network, MVRP provides a method to dynamically share VLAN information and configure the needed VLANs.
The multicast tree construction is receiver driven and is initiated by network nodes that are close to the receivers. IP multicast scales to a large receiver population. The IP multicast model has been described by Internet architect Dave Clark as, "You put packets in at one end, and the network conspires to deliver them to anyone who asks." [5]
Multicast: In multicast communication, data is sent from one source to multiple specific receivers, often to a defined group within a network. This is efficient in scenarios like live streaming, where the data is only sent once but received by multiple devices interested in the same content.
In older Cisco IOS releases, PIM-DM would re-flood all the multicast traffic every 3 minutes. This is fine for low volume multicast, but not higher bandwidth multicast packet streams. More recent Cisco IOS versions support a new feature called PIM Dense Mode State Refresh, since 12.1(5)T.
A limitation of Port Aggregation Protocol is that all the physical ports in the aggregation group must reside on the same switch. Cisco's 6500 and the 4500E platforms, remove this limitation using Virtual Switching System (VSS), [1] which allows port channels to be split between two chassis. PAgP is not supported in Cisco Nexus Switches.
A switch will, by default, flood multicast traffic to all the ports in a broadcast domain (or the VLAN equivalent). Multicast can cause unnecessary load on host devices by requiring them to process packets they have not solicited. When purposefully exploited, this can form the basis of a denial-of-service attack. IGMP snooping is designed to ...