Ads
related to: automotive cooling system pressure tester
Search results
Results From The WOW.Com Content Network
A calibrated pressure-relief valve is usually incorporated in the radiator's fill cap. This pressure varies between models, but typically ranges from 4 to 30 psi (30 to 200 kPa). [4] As the coolant system pressure increases with a rise in temperature, it will reach the point where the pressure relief valve allows excess pressure to escape.
Inches of mercury is also used in automotive cooling system vacuum test and fill tools. A technician will use this tool to remove air from modern automotive cooling systems, test the system's ability to hold vacuum, and subsequently refill using the vacuum as suction for the new coolant. Typical minimum vacuum values are between 22 and 27 inHg.
Engine coolant temperature sensor; Hall effect sensor; Wheel speed sensor; Airbag sensors; Automatic transmission speed sensor; Brake fluid pressure sensor; Camshaft position sensor (CMP) Cylinder Head Temperature gauge; Engine crankcase pressure sensor; Exhaust gas temperature sensor; Fuel level sensor; Fuel pressure sensor; Knock sensor ...
The temperature of the cooling air may range from well below freezing to 50 °C. Further, while engines in long-haul boat or rail service may operate at a steady load, road vehicles often see widely varying and quickly varying load. Thus, the cooling system is designed to vary cooling so the engine is neither too hot nor too cold.
Compression tests should normally be done with all spark plugs removed to maximize cranking speed. Cranking compression is a dynamic test of the actual low-speed pumping action, where peak cylinder pressure is measured and stored. A compression tester. Leak-down testing is a static test. Leak-down tests cylinder leakage paths.
Car engine wax thermostatic element. The wax thermostatic element was invented in 1934 by Sergius Vernet (1899–1968). [1] Its principal application is in automotive thermostats used in the engine cooling system. The first applications in the plumbing and heating industries were in Sweden (1970) and in Switzerland (1971).