Search results
Results From The WOW.Com Content Network
Van de Graaff generator diagram. A simple Van de Graaff generator consists of a belt of rubber (or a similar flexible dielectric material) moving over two rollers of differing material, one of which is surrounded by a hollow metal sphere. A comb-shaped metal electrode with sharp points (2 and 7 in the diagram), is positioned near each roller ...
English: Diagram of revolving-field single phase generator with two poles. As the rotor turns, the lines of force at two poles are cut by the coils inducing current. The output from two coils are "in phase". The direction of current changes to the opposite site every 180 degrees of rotation.
As an example, a 250 kVA motor–generator operating at 300 ampere of full load current will require 1550 ampere of in-rush current during a re-closure after 5 seconds. This example used a fixed mounted flywheel sized to result in a 1 ⁄ 2 Hz per second slew rate. The motor–generator was a vertical type two-bearing machine with oil-bath ...
Four wool spinning machines driven by belts from an overhead lineshaft (Leipzig, Germany, circa 1925) The belt drives of the Mueller Mill, model and reality, in motionA line shaft is a power-driven rotating shaft for power transmission that was used extensively from the Industrial Revolution until the early 20th century.
An engine–generator is the combination of an electrical generator and an engine (prime mover) mounted together to form a single piece of equipment. This combination is also called an engine–generator set or a gen-set. In many contexts, the engine is taken for granted and the combined unit is simply called a generator. An engine–generator ...
[1] [2] When the equipment is down, production requiring the equipment may be delayed. Bearings or mechanical seals may be damaged and need to be replaced. Shaft alignment is the process of aligning two or more shafts with each other to within a tolerated margin. The process is used for machinery before the machinery is put in service.
For forty years the arithmometer was the only type of mechanical calculator available for sale until the industrial production of the more successful Odhner Arithmometer in 1890. [ 8 ] The comptometer , introduced in 1887, was the first machine to use a keyboard that consisted of columns of nine keys (from 1 to 9) for each digit.
The open belt drive has parallel shafts rotating in the same direction, whereas the cross-belt drive also bears parallel shafts but rotate in opposite direction. The former is far more common, and the latter not appropriate for timing and standard V-belts unless there is a twist between each pulley so that the pulleys only contact the same belt ...