Search results
Results From The WOW.Com Content Network
A torque converter is a device, usually implemented as a type of fluid coupling, that transfers rotating power from a prime mover, like an internal combustion engine, to a rotating driven load. In a vehicle with an automatic transmission, the torque converter connects the prime mover to the automatic gear train, which then drives the load.
Viscous couplings are used as the center differential in cars such as the Toyota Celica GT-Four, and also as a limited slip differential (LSD) in rear axles. They offer a cheaper way to implement four-wheel-drive than technologies like the mechanical-transfer Torsen differentials. Volvo, Subaru, Land Rover, Vauxhall/Opel, and many others have ...
Fluid Drive is the trademarked name that Chrysler Corporation assigned to a transmission driveline combination which replaced the flywheel with a hydraulic coupling and performed the same function as a modern torque converter, only without torque multiplication. A conventional clutch, and three- or four-speed manual transmission was installed ...
Daimler car fluid flywheel of the 1930s. A fluid coupling or hydraulic coupling is a hydrodynamic or 'hydrokinetic' device used to transmit rotating mechanical power. [1] It has been used in automobile transmissions as an alternative to a mechanical clutch. It also has widespread application in marine and industrial machine drives, where ...
A continuously variable transmission (CVT) is an automated transmission that can change through a continuous range of gear ratios. This contrasts with other transmissions that provide a limited number of gear ratios in fixed steps. The flexibility of a CVT with suitable control may allow the engine to operate at a constant angular velocity ...
Transmission (mechanical device) A transmission (also called a gearbox) is a mechanical device which uses a gear set —two or more gears working together—to change the speed, direction of rotation, or torque multiplication/reduction in a machine. [1][2] Transmissions can have a single fixed-gear ratio, multiple distinct gear ratios, or ...
The design of most manual transmissions for cars is that gear ratios are selected by locking selected gear pairs to the output shaft inside the transmission. This is a fundamental difference compared with a typical hydraulic automatic transmission, which uses an epicyclic (planetary) design, and a hydraulic torque converter.
A hydraulic motor is a mechanical actuator that converts hydraulic pressure and flow into torque and angular displacement (rotation). The hydraulic motor is the rotary counterpart of the hydraulic cylinder as a linear actuator. Most broadly, the category of devices called hydraulic motors has sometimes included those that run on hydropower ...