Ads
related to: mg ml to ug calculator download free
Search results
Results From The WOW.Com Content Network
In the metric system, a microgram or microgramme is a unit of mass equal to one millionth (1 × 10 −6) of a gram.The unit symbol is μg according to the International System of Units (SI); the recommended symbol in the United States and United Kingdom when communicating medical information is mcg.
Atmospheric pollutant concentrations expressed as mass per unit volume of atmospheric air (e.g., mg/m 3, μg/m 3, etc.) at sea level will decrease with increasing altitude because the atmospheric pressure decreases with increasing altitude. The change of atmospheric pressure with altitude can be obtained from this equation: [2]
A solution with 1 g of solute dissolved in a final volume of 100 mL of solution would be labeled as "1%" or "1% m/v" (mass/volume). This is incorrect because the unit "%" can only be used for dimensionless quantities. Instead, the concentration should simply be given in units of g/mL.
Parts-per notation is often used describing dilute solutions in chemistry, for instance, the relative abundance of dissolved minerals or pollutants in water.The quantity "1 ppm" can be used for a mass fraction if a water-borne pollutant is present at one-millionth of a gram per gram of sample solution.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
The MIC is often expressed in micrograms per milliliter (μg/mL) or milligrams per liter (mg/L). In diagnostic labs, MIC test results are used to grade the susceptibility of microbes. These grades are assigned based on agreed upon values called breakpoints.
IMO PSPC (performance standard for protective coatings) regulations set a maximum allowable concentration of soluble salts on a surface to be coated, measured as sodium chloride, of 50 mg•m −2. The maximum amount of salt allowed on a surface prior to coating application is typically determined by the coating supplier and the user, such as a ...
The original line, sometimes referred to as the Rumack–Matthew line, starts at 200 μg/mL at 4 hours and was published in 1975 by Barry H. Rumack and Henry Matthew. [5] When the NAC study began in 1976, the U.S. Food and Drug Administration (FDA) required a line that was 25% below the original.