Search results
Results From The WOW.Com Content Network
Curing is a chemical process employed in polymer chemistry and process engineering that produces the toughening or hardening of a polymer material by cross-linking of polymer chains. [1] Even if it is strongly associated with the production of thermosetting polymers , the term "curing" can be used for all the processes where a solid product is ...
In materials science, a thermosetting polymer, often called a thermoset, is a polymer that is obtained by irreversibly hardening ("curing") a soft solid or viscous liquid prepolymer . [1] Curing is induced by heat or suitable radiation and may be promoted by high pressure or mixing with a catalyst .
Curing of epoxy resins is an exothermic reaction and in some cases produces sufficient heat to cause thermal degradation if not controlled. [28] Curing does induce residual stress in epoxy systems which have been studied. [29] The induced stresses may be alleviated with flexibilisers.
A thermoset polymer matrix is a synthetic polymer reinforcement where polymers act as binder or matrix to secure in place incorporated particulates, fibres or other reinforcements. They were first developed for structural applications, [ 1 ] such as glass-reinforced plastic radar domes on aircraft and graphite - epoxy payload bay doors on the ...
During the printing cycle, the ink is first slightly cured before being printed at high temperature into the desired 3D structure, and followed by a second curing step in an oven after printing. The printed epoxy parts can then be recycled by dissolving in ethylene glycol at high temperature and reused as ink in a new printing cycle.
In the third step, the specimen is then placed in a bath of liquid polymer, such as silicone rubber, polyester, or epoxy resin. In a partial vacuum, the acetone is made to boil at a low temperature. As the acetone vaporizes and leaves the cells, it draws the liquid polymer in behind it, leaving a cell filled with liquid plastic. [5]
B-staging is a process that utilizes heat or UV light to remove the majority of solvent from an adhesive, thereby allowing a construction to be “staged”.In between adhesive application, assembly and curing, the product can be held for a period of time, without sacrificing performance.
Under thermal effect, the end of polymer chain departs, and forms low free radical which has low activity. Then according to the chain reaction mechanism, the polymer loses the monomer one by one. However, the molecular chain doesn't change a lot in a short time. The reaction is shown below. [5] This process is common for polymethymethacrylate ...