Search results
Results From The WOW.Com Content Network
New Process Gear A833 RPO MY6 or MM7 — 4-speed longitudinal A833 overdrive transmission made by New Process Gear for early to mid 1980s General Motors Light Trucks; Muncie SM465 — 4-speed longitudinal manual used in 68- 91 Chevy 1/2 3/4 and 1 ton trucks; New Venture Gear NV1500 — 5-speed longitudinal manual made by New Venture Gear
The transmission has a 7.05:1 ratio first gear, which is one of the lowest "granny" gears ever produced in a production transmission. It weighs 135lb, which is 40 pounds less than the SM465 that replaced it. While the construction is dated by modern standards, these are sought after by off-road enthusiasts due to the ruggedness and gear ratios. [1]
Starting in 1973, AMC discontinued the use of the adapter ring, as it sourced a TH400 case from GM with the AMC bellhousing pattern already cast. The TH400 AMC case was used until the end of 1979 model production. The 232 cu in (3.8 L) I6 used in 1970-72 Jeep DJ "Postal Jeep" was backed up by the Borg-Warner T-35 3-speed automatic.
The transmission identification number or source serial number (chassis VIN) is usually located close to the transmission code. This number will contain a division identification number, the model year, and the assembly plant and production sequence (last 6 digits) of the vehicle identification number (VIN) stamped onto the transmission.
1968 Camaro RS 327 (original optional stripe was black) 1968 Chevrolet Camaro SS convertible. The styling of the 1968 Camaro was very similar to the 1967 design. With the introduction of Astro Ventilation, a fresh-air-inlet system, the side vent windows were deleted. Side marker lights were added on the front and rear fenders as part of safety ...
By selecting L from stationary, or before an upward gear change into 2nd gear, the transmission will become locked in 1st gear. By selecting L from D2 or D1 while in 2nd gear, the transmission will become locked in 2nd gear or from D2 or D1 when cruising below 55 m.p.h (88 k.p.h.) will effect an immediate downward change and lock in 2nd gear.
1968–1969 Chevrolet Camaro (most were dealer installed, but in 1969 both the L-72 and the ZL-1 were factory options) 427 production codes: LS-1: produced 1969, 10.25:1 compression, Q-jet carburetor, oval port closed chamber heads, hydraulic lifters, nodular iron crankshaft, and two-bolt main caps. It produced 335 hp (250 kW). [37]
The T-5 is a T4 with an added overdrive gear. [2] The T-5 carries a part number of 1352-000-xxx, where xxx is a three-digit application-specific number ranging from 001 to 260 that also can be used to distinguish World Class from Standard T-5 transmissions. [3]: Tables 3-1 & 4-1 The first T-5s were installed in the AMC Spirit/Concord.