Search results
Results From The WOW.Com Content Network
In radio communications, single-sideband modulation (SSB) or single-sideband suppressed-carrier modulation (SSB-SC) is a type of modulation used to transmit information, such as an audio signal, by radio waves. A refinement of amplitude modulation, it uses transmitter power and bandwidth more efficiently.
Failure of the BFO to match the original carrier frequency when receiving such a signal will cause a heterodyne. Suppressed carriers are often used for single sideband (SSB) transmissions, such as for amateur radio on shortwave. That system is referred to in full as SSB suppressed carrier or (SSB-SC).
Single-sideband modulation with full carrier (e.g. as used by CHU) J: Single-sideband with suppressed carrier (e.g. Shortwave utility and amateur stations) K: Pulse-amplitude modulation: L: Pulse-width modulation (e.g. as used by WWVB) M: Pulse-position modulation: N: Unmodulated carrier (steady, single-frequency signal) P: Sequence of pulses ...
The first such analog modulating waveforms applied to radio carriers were human voice signals picked up by microphone sensors and applied to the carrier waveforms. The resulting analog voice modes are known today as: Amplitude modulation (AM) Double-sideband suppressed carrier (DSB-SC) Independent sideband (ISB) Single sideband (SSB)
This is an increase compared to normal AM transmission (DSB) that has a maximum efficiency of 33.333%, since 2/3 of the power is in the carrier which conveys no useful information and both sidebands containing identical copies of the same information. Single Side Band Suppressed Carrier (SSB-SC) is 100% efficient. Spectrum plot of a DSB-SC signal:
The term DSB reduced-carrier normally implies enough carrier remains in the transmission to enable a receiver circuit to regenerate a strong carrier or at least synchronise a phase-locked loop but there are forms where the carrier is removed completely, producing double sideband with suppressed carrier (DSB-SC). Suppressed carrier systems ...
Waterfall plot of a 146.52 MHz radio carrier, with amplitude modulation by a 1,000 Hz sinusoid. Two strong sidebands at + and - 1 kHz from the carrier frequency are shown. A carrier, frequency modulated by a 1,000 Hz sinusoid. The modulation index has been adjusted to around 2.4, so the carrier frequency has small amplitude. Several strong ...
SSB, or SSB-AM single-sideband full carrier modulation, is very similar to single-sideband suppressed carrier modulation (SSB-SC). It is used where it is necessary to receive the audio on an AM receiver, while using less bandwidth than with double sideband AM. Due to high distortion, it is seldom used.