Search results
Results From The WOW.Com Content Network
Wound-rotor motors can be started with low inrush current, by inserting high resistance into the rotor circuit; as the motor accelerates, the resistance can be decreased. [ 1 ] Compared to a squirrel-cage rotor , the rotor of the slip ring motor has more winding turns; the induced voltage is then higher, and the current lower, than for a ...
A synchronous motor may have a squirrel-cage winding embedded in its rotor, used to increase the motor starting torque and so decrease the time to accelerate to synchronous speed. The squirrel cage winding of a synchronous machine will generally be smaller than for an induction machine of similar rating.
[a] An induction motor's rotor can be either wound type or squirrel-cage type. Three-phase squirrel-cage induction motors are widely used as industrial drives because they are self-starting, reliable, and economical. Single-phase induction motors are used extensively for smaller loads, such as garbage disposals and stationary power tools.
A squirrel-cage rotor connected to the output shaft rotates within the stator at slightly less than the rotating field from the stator. Within the squirrel-cage rotor is a freely rotating permanent magnet rotor, which is locked in with rotating field from the stator. The effect of the inner rotor is to reenforce the field from the stator. [1]
This creates torque that pulls the rotor into alignment with the nearest pole of the stator field. At synchronous speed the rotor is thus "locked" to the rotating stator field. This cannot start the motor, so the rotor poles usually have squirrel-cage windings embedded in them, to provide torque below synchronous speed. The machine thus starts ...
A metal cylinder will work as rotor, but to improve efficiency a "squirrel cage" rotor or a rotor with closed windings is usually used. The speed of asynchronous induction machines will decrease with increased load because a larger speed difference between stator and rotor is necessary to set up sufficient rotor current and rotor magnetic field.
A cage winding is a short-circuited squirrel-cage rotor, a wound winding is connected externally through slip rings. 9. Mostly single-phase with some three-phase. Abbreviations: BLAC – Brushless AC; BLDC – Brushless DC; BLDM – Brushless DC motor; EC – Electronic commutator; PM – Permanent magnet; IPMSM – Interior permanent-magnet ...
Squirrel-cage asynchronous: The most common type of shaded-pole motor in fractional horsepower use has a squirrel-cage rotor that consists of a laminated steel cylinder with conductive copper or aluminum bars embedded lengthwise in its surface, connected at the ends. Synchronous permamagnetized uses a magnetized rotor, e.g. a permanent magnet ...