When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Enthalpy of sublimation - Wikipedia

   en.wikipedia.org/wiki/Enthalpy_of_sublimation

   In thermodynamics, the enthalpy of sublimation, or heat of sublimation, is the heat required to sublimate (change from solid to gas) one mole of a substance at a given combination of temperature and pressure, usually standard temperature and pressure (STP). It is equal to the cohesive energy of the solid.

3. Sublimation (phase transition) - Wikipedia

   en.wikipedia.org/wiki/Sublimation_(phase_transition)

   Solid carbon dioxide sublimes rapidly along the solid-gas boundary (sublimation point) below the triple point (e.g., at the temperature of −78.5 °C, at atmospheric pressure), whereas its melting into liquid CO 2 can occur along the solid-liquid boundary (melting point) at pressures and temperatures above the triple point (i.e., 5.1 atm, − ...

4. Dye-sublimation printing - Wikipedia

   en.wikipedia.org/wiki/Dye-sublimation_printing

   The most common dyes used for sublimation activate at 350 degrees Fahrenheit / 175 degrees Celsius. However, a range of 380 to 420 degrees Fahrenheit / 195 to 215 degrees Celsius is normally recommended for optimal color. The result of the sublimation transfer process is a nearly permanent, high-resolution, full-color print.

5. Triple point - Wikipedia

   en.wikipedia.org/wiki/Triple_point

   A typical phase diagram.The solid green line applies to most substances; the dashed green line gives the anomalous behavior of water. In thermodynamics, the triple point of a substance is the temperature and pressure at which the three phases (gas, liquid, and solid) of that substance coexist in thermodynamic equilibrium. [1]

6. Outgassing - Wikipedia

   en.wikipedia.org/wiki/Outgassing

   Outgassing is a possible source of many tenuous atmospheres of terrestrial planets or moons. [6] Many materials are volatile relative to the extreme vacuum of outer space, and may evaporate or even boil at ambient temperature.

7. Wood drying - Wikipedia

   en.wikipedia.org/wiki/Wood_drying

   where is a function of the temperature T and a typical wood dimension L and has units of time. The typical wood dimension is roughly the smallest value of (,, /) which are the radial, tangential and longitudinal dimensions respectively, in inches, with the longitudinal dimension divided by ten because water diffuses about 10 times more rapidly ...