Search results
Results From The WOW.Com Content Network
MAC addresses are primarily assigned by device manufacturers, and are therefore often referred to as the burned-in address, or as an Ethernet hardware address, hardware address, or physical address. Each address can be stored in the interface hardware, such as its read-only memory , or by a firmware mechanism.
TCP/IP defines the addresses 192.168.4.0 (network ID address) and 192.168.4.255 (broadcast IP address). The office's hosts send packets to addresses within this range directly, by resolving the destination IP address into a MAC address with the Address Resolution Protocol (ARP) sequence and then encapsulates the IP packet into a MAC frame ...
MACFF then uses DHCP snooping to check whether the host has a gateway Access Router. If it does, MACFF uses a form of Proxy ARP to reply to any ARP requests, giving the router's MAC address. This forces the host to send all traffic to the router, even traffic destined to a host in the same subnet as the source. The router receives the traffic ...
A broadcast address is a network address used to transmit to all devices connected to a multiple-access communications network. A message sent to a broadcast address may be received by all network-attached hosts. In contrast, a multicast address is used to address a specific group of devices, and a unicast address is used to address a single ...
This address is used by only one physical router at a time, and it will reply with this MAC address when an ARP request is sent for the virtual router's IP address. Physical routers within the virtual router must communicate within themselves using packets with multicast IP address 224.0.0.18 and IP protocol number 112 [1] for IPv4, or ff02::12 ...
An enterprise local area network (LAN) that connects to the corporate network by only one router, or multiple default routers connected to the same logical upstream destination. A single LAN which never carries packets between multiple routers connected to it. All traffic is to and/or from local hosts. The routers will only route packets into ...
The local network addresses used in IEEE 802 networks and FDDI networks are called MAC addresses; they are based on the addressing scheme that was used in early Ethernet implementations. A MAC address is intended as a unique serial number. MAC addresses are typically assigned to network interface hardware at the time of manufacture.
Each device connected to a switch port can transfer data to any of the other ports at any time and the transmissions will not interfere. [a] Because broadcasts are still being forwarded to all connected devices by the switch, the newly formed network segment continues to be a broadcast domain. Switches may also operate at higher layers of the ...