When.com Web Search

  1. Ads

    related to: test ethernet speed to router

Search results

  1. Results From The WOW.Com Content Network
  2. Measuring network throughput - Wikipedia

    en.wikipedia.org/wiki/Measuring_network_throughput

    When talking about circuit bit rates, people will interchangeably use the terms throughput, bandwidth and speed, and refer to a circuit as being a '64 k' circuit, or a '2 meg' circuit — meaning 64 kbit/s or 2 Mbit/s (see also the List of connection bandwidths). However, a '64 k' circuit will not transmit a '64 k' file in one second.

  3. Fast Ethernet - Wikipedia

    en.wikipedia.org/wiki/Fast_Ethernet

    3Com 3C905B-TX 100BASE-TX PCI network interface card. 100BASE-TX is the predominant form of Fast Ethernet, and runs over two pairs of wire inside a Category 5 or above cable. Cable distance between nodes can be up to 100 metres (328 ft). One pair is used for each direction, providing full-duplex operation at 100 Mbit/s in each direction.

  4. Speedtest.net - Wikipedia

    en.wikipedia.org/wiki/Speedtest.net

    Each test measures the data rate for the download direction, i.e. from the server to the user computer, and the upload data rate, i.e. from the user's computer to the server. The tests are performed within the user's web browser or within mobile apps. As of 17 February 2024, over 52.3 billion Internet speed tests have been completed. [8]

  5. Network throughput - Wikipedia

    en.wikipedia.org/wiki/Network_throughput

    For example, a gateway router supporting a populated class B subnet, handling 10 × 100 Mbit/s Ethernet channels, must examine 16 bits of address to determine the destination port for each packet. This translates into 81913 packets per second (assuming maximum data payload per packet) with a table of 2^16 addresses this requires the router to ...

  6. Y.156sam - Wikipedia

    en.wikipedia.org/wiki/Y.156sam

    The Internet Engineering Task Force RFC 2544 is a benchmarking methodology for network interconnect devices. This request for comment (RFC) was created in 1999 as a methodology to benchmark network devices such as hubs, switches and routers as well as to provide accurate and comparable values for comparison and benchmarking.

  7. ping (networking utility) - Wikipedia

    en.wikipedia.org/wiki/Ping_(networking_utility)

    ping is a computer network administration software utility used to test the reachability of a host on an Internet Protocol (IP) network. It is available for virtually all operating systems that have networking capability, including most embedded network administration software.