Search results
Results From The WOW.Com Content Network
The pulse-repetition frequency (PRF) is the number of pulses of a repeating signal in a specific time unit. The term is used within a number of technical disciplines, notably radar . In radar, a radio signal of a particular carrier frequency is turned on and off; the term "frequency" refers to the carrier, while the PRF refers to the number of ...
Pulse-Doppler typically uses medium pulse repetition frequency (PRF) from about 3 kHz to 30 kHz. The range between transmit pulses is 5 km to 50 km. Range and velocity cannot be measured directly using medium PRF, and ambiguity resolution is required to identify true range and speed.
Staggered PRF is only one of several similar techniques used for this, including jittered PRF (where the pulse timing is varied in a less-predictable manner), pulse-frequency modulation, and several other similar techniques whose principal purpose is to reduce the probability of unintentional synchronicity.
The difference between the sample numbers where reflection signal is found for these two PRF will be about the same as the number of the ambiguous range intervals between the radar and the reflector (i.e.: if the reflection falls in sample 3 for PRF 1 and in sample 5 for PRF 2, then the reflector is in ambiguous range interval 2=5-3).
Pulse width is an important measure in radar systems. Radars transmit pulses of radio frequency energy out of an antenna and then listen for their reflection off of target objects. The amount of energy that is returned to the radar receiver is a function of the peak energy of the pulse, the pulse width, and the pulse repetition frequency.
Areas outside the blue zones are blind ranges and blind velocities, which are filled in using multiple PRF and frequency agility. Pulse Doppler radar may have 50 or more pulses between the radar and the reflector. Pulse Doppler relies on medium pulse repetition frequency (PRF) from about 3 kHz to 30 kHz.
The received signals are also compared using the frequency ambiguity resolution process. A blind velocity occurs when Doppler frequency falls close to the PRF. This folds the return signal into the same filter as stationary clutter reflections. Rapidly alternating different PRF while scanning eliminates blind frequencies.
Scalloping happens in a two PRF detection scenario when target velocity produces a blind velocity for one PRF while the target is at the blind range of the other PRF. The blind velocity for a specific pulse repetition frequency (PRF) is an integer multiple of the following, which causes the signal to have zero doppler.