Ads
related to: micro usb 3.0 connector ends with c and full
Search results
Results From The WOW.Com Content Network
On the device side, a modified Micro-B plug (Micro-B SuperSpeed) is used to cater for the five additional pins required to achieve the USB 3.0 features (USB-C plug can also be used). The USB 3.0 Micro-B plug effectively consists of a standard USB 2.0 Micro-B cable plug, with an additional 5 pins plug "stacked" to the side of it.
USB 3.0 and later specifications define one dedicated pair for USB 2.0 compatibility and two or four pairs for data transfer: two data wire pairs realising full-duplex (FDx) for single lane (×1) variants require at least SuperSpeed (SS) connectors; four pairs realising full-duplex for two lane (×2) variants require USB-C connectors.
USB 3.0 also introduced a new Micro-B cable plug, which consists of a standard USB 1.x/2.0 Micro-B cable plug, with an additional 5-pin plug "stacked" beside it. That way, the USB 3.0 Micro-B host receptacle preserves its backward compatibility with the USB 1.x/2.0 Micro-B cable plug, allowing devices with USB 3.0 Micro-B ports to run at USB 2. ...
Some non-compliant cables with a USB-C connector on one end and a legacy USB-A plug or Micro-B receptacle (receptacles also usually being invalid on cables, but see known exceptions in the sections on Hosts and peripheral devices and Audio adapter accessory mode above) on the other end incorrectly terminate the Configuration Channel (CC) with a ...
High-speed devices must also be capable of falling-back to full-speed as well, making high-speed devices backward compatible with USB 1.1 hosts. Connectors are identical for USB 2.0 and USB 1.x. SuperSpeed (SS) rate of 5.0 Gbit/s. The written USB 3.0 specification was released by Intel and its partners in August 2008.
The USB port is fully compatible with USB 5 Gbit/s (USB 3.0), USB 480 Mbit/s (USB 2.0) and USB 12 Mbit/s (1.1); USB 3.0 devices are compatible, but will operate at USB 2.0 speed if internal USB 3.0 connector is not connected.