Ads
related to: flange bolting size chart dimensions diagram printable version 10 8 5 upgrade
Search results
Results From The WOW.Com Content Network
The flange design, inner and outer conductor dimensions are standardized, by EIA, in the RS-225, 50 Ω (ohm), and RS-259, 75 Ω, standards.They are commonly referred to by the inner diameter of the outer conductor in fractional inches.
The curve representing a clamped parts-to-bolt stiffness ratio of 0.01 shows that when the relative stiffness of the clamped parts is very low, almost all of the load is transferred to the bolt, down to the point where a compressive load equals the preload, and separation at the bolt head occurs, reducing the force in the bolt to zero.
A few sizes are close enough to interchange for most purposes, such as 19 mm (close to 3 ⁄ 4 inch (19.05 mm)), 8 mm (close to 5 ⁄ 16 inch (7.94 mm)) and 4 mm (close to 5 ⁄ 32 inch (3.97 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.
The ASME B16 Standardization of Valves Flanges, Fittings and Gaskets Committee, which operates under ASME’s Board on Pressure Technology Codes and Standards is responsible for standards covering valves, flanges, pipe fittings, gaskets and valve actuators for use in pressure services.
Standard sizes are indicated by the nominal inner diameter in millimeters for flanges 10 through 50 mm in diameter. [2] Sizes 10, 20 and 32 are less common sizes (see Renard numbers ). Some sizes share their flange dimensions with their respective larger neighbor and use the same clamp size.
For example, AN6 bolt has a 3 ⁄ 8-24 thread [3] whereas an -6 AN fitting has a 9 ⁄ 16-18 thread. [ 4 ] Originally parts were made compliant to the specification MIL-F-5509, but they are now controlled under SAE AS (Aerospace Standards) specifications AS4841 through AS4843 and AS4875.