Ads
related to: clarke wooden machinist's tool chest parts list replacement parts
Search results
Results From The WOW.Com Content Network
Simple wooden toolbox. A toolbox could refer to several types of storage to hold tools. It could mean a small portable box that can carry a few tools to a project location or a large storage system set on casters. [1] Modern toolboxes are predominantly metal or plastic. Wood was the material of choice for toolboxes built beginning in the early ...
Snap-on, Bahco, Blue-Point, Williams, CDI Torque Products, [27] Sun diagnostic tools in Europe and Brazil: Hand tools, air tools, power tools, diagnostic tools, assorted automotive tools Sortimo: Zusmarshausen, Germany: Sortimo: in-vehicle equipment, storage system for parts and tools Stanley Black & Decker: Connecticut, US
Eli Terry was using interchangeable parts using a milling machine as early as 1800. Ward Francillon, a horologist, concluded in a study that Terry had already accomplished interchangeable parts as early as 1800. The study examined several of Terry's clocks produced between 1800–1807. The parts were labelled and interchanged as needed.
H. Gerstner & Sons, Inc. is a manufacturer of wooden tool chests based in Dayton, Ohio.Started in 1906, it has remained family-owned. [1] Of more than twenty manufacturers building wooden tool chests for journeymen in the early 20th century, H. Gerstner & Sons is the only one to still exist.
A rail repair dutchman is typically a 4–6-inch (100–150 mm) long piece of rail that is cut in advance for the purpose and carried by a section crew. If the gang finds a rail with a chipped or broken end, they remove the connector plates ( fishplates ), cut out the damaged section, replace it with the dutchman, and bolt the connectors back ...
A biography of a machine tool builder that also contains some general history of the industry. Rolt, L. T. C. (1965), A Short History of Machine Tools, Cambridge, Massachusetts, USA: MIT Press, OCLC 250074. Co-edition published as Rolt, L. T. C. (1965), Tools for the Job: a Short History of Machine Tools, London: B. T. Batsford, LCCN 65080822.
Several machine collets (top and centre) and a dismantled pin chuck (below). Generally, a collet chuck, [3] considered as a unit, consists of a tapered receiving sleeve (sometimes integral with the machine spindle), the collet proper (usually made of spring steel) which is inserted into the receiving sleeve, and (often) a cap that screws over the collet, clamping it via another taper.
A self-centering chuck, also known as a scroll chuck, [2] uses jaws, interconnected via a scroll gear (scroll plate), to hold onto a tool or workpiece. Because they most often have three jaws, the term three-jaw chuck without other qualification is understood by machinists to mean a self-centering three-jaw chuck.