Search results
Results From The WOW.Com Content Network
Van Diemen RF01 Racing Car Suspension. Suspension is the system of tires, tire air, springs, shock absorbers and linkages that connects a vehicle to its wheels and allows relative motion between the two. [1] Suspension systems must support both road holding/handling and ride quality, [2] which are at odds with each other. The tuning of ...
MagneRide is an automotive adaptive suspension with magnetorheological damper system developed by the Delphi Automotive corporation, [1] [2] that uses magnetically controlled dampers, or shock absorbers, for a highly adaptive ride. As opposed to traditional suspension systems, MagneRide has no mechanical valves or even small moving parts that ...
A beam axle, rigid axle, or solid axle is a dependent suspension design in which a set of wheels is connected laterally by a single beam or shaft. Beam axles were once commonly used at the rear wheels of a vehicle, but historically, they have also been used as front axles in four-wheel-drive vehicles.
A multi-link suspension is a type of independent vehicle suspension having three or more control links per wheel. [1] These arms do not have to be of equal length, and may be angled away from their "obvious" direction. It was first introduced in the late 1960s on the Mercedes-Benz C111 [2] and later on their W201 and W124 series. [3] [4]
Self-levelling suspension; Sliding pillar suspension; Slip angle; Spaceframe chassis; Speed Dependent Damping Control; Speed wobble; Spindle (automobile) Sprung mass; Steering knuckle; Strut; Strut bar; Car suspension; Suspension keel; Suspension link; Swing axle
A semi-trailing arm suspension is a supple independent rear suspension system for automobiles where each wheel hub is located only by a large, roughly triangular arm that pivots at two points. Viewed from the top, the line formed by the two pivots is somewhere between parallel and perpendicular to the car's longitudinal axis; it is generally ...
This increases the suspension's roll stiffness—its resistance to roll in turns. The first stabilizer bar patent was awarded to Canadian inventor Stephen Coleman of Fredericton, New Brunswick on April 22, 1919. [1] [2] Anti-roll bars were unusual on pre-WW2 cars due to the generally much stiffer suspension and acceptance of body roll.
This is the most common, widely used front suspension system in cars today. It is a very simple and effective design that uses a strut-type spring and shock absorber that work as a team that will pivot on a single ball joint. This system was popularized in British Fords in the 1950s, then adopted by BMW (1962) and Porsche (1963).