Ads
related to: astm d 698 testing procedure manual
Search results
Results From The WOW.Com Content Network
The original Proctor test, ASTM D698 / AASHTO T99, uses a 4-inch-diameter (100 mm) by 4.584-inch-high (116.4 mm) mold which holds 1/30 cubic feet of soil, and calls for compaction of three separate lifts of soil using 25 blows by a 5.5 lb hammer falling 12 inches, for a compactive effort of 12,375 ft-lbf/ft 3.
It is standardized as ASTM D93, EN ISO 2719 and IP 34 [1] The United States Environmental Protection Agency (EPA) has also published Method 1010A: Test Methods for Flash Point by Pensky-Martens Closed Cup Tester, part of Test Methods for Evaluating Solid Waste, Physical/Chemical Methods, which references the ASTM standard series
The Barcol hardness test is generally used on soft materials such as rigid plastics. It measures hardness based on indentation of a sharp point with a flat tip. The test is performed using a similar method and indentation device as that used to measure Shore D hardness, however the Shore D indentor has a round tip. [4]
ASTM International, formerly known as American Society for Testing and Materials, is a standards organization that develops and publishes voluntary consensus technical international standards for a wide range of materials, products, systems and services. Some 12,575 apply globally.
For measuring Shore A the foot indents the material while for Shore D the foot penetrates the surface of the material. Material for testing needs to be in laboratory climate storage at least one hour before testing. Measuring time is 15s. Force is 1 kg +0.1 kg for Shore A, and 5 kg +0.5 kg for Shore D. Five measurements need to be taken.
A test method is a method for a test in science or engineering, such as a physical test, chemical test, or statistical test. It is a definitive procedure that produces a test result. [ 1 ] In order to ensure accurate and relevant test results, a test method should be "explicit, unambiguous, and experimentally feasible.", [ 2 ] as well as ...
ASTM D6834- Standard Test Method for Determining Product Leakage from a Package with a Mechanical Pump Dispenser ASTM E493- Standard Test Methods for Leaks Using the Mass Spectrometer Leak Detector in the Inside-Out Testing Mode ASTM F2338- Standard Test Method for Nondestructive Detection of Leaks in Packages by Vacuum Decay Method
ASTM D-5778 "Standard Test Method for Performing Electronic Friction Cone and Piezocone Penetration Testing of Soils". International Reference Test Procedure for CPT and CPTU - International Society of Soil Mechanics and Geotechnical Engineering (ISSMGE) Mayne, Paul; Auxt, Jay A.; Mitchell, James K.; Yilmaz, Recep (October 4–5, 1995).