When.com Web Search

  1. Ad

    related to: best economy temperature for boiler repair costs

Search results

  1. Results From The WOW.Com Content Network
  2. Economizer - Wikipedia

    en.wikipedia.org/wiki/Economizer

    The temperature of the gases can be lowered from the boiling temperature of the fluid to little more than the incoming feed water temperature while preheating that feed water to the boiling temperature. High pressure boilers typically have larger economizer surfaces than low pressure boilers.

  3. Central heating - Wikipedia

    en.wikipedia.org/wiki/Central_heating

    The energy cost of heating is one of the main costs of operating a building in a cold climate. Some central heating plants can switch fuels for reasons of economy and convenience; for example, a home owner may install a wood-fired furnace with electrical backup for occasional unattended operation.

  4. Thermal efficiency - Wikipedia

    en.wikipedia.org/wiki/Thermal_efficiency

    In thermodynamics, the thermal efficiency is a dimensionless performance measure of a device that uses thermal energy, such as an internal combustion engine, steam turbine, steam engine, boiler, furnace, refrigerator, ACs etc.

  5. Cost estimates come back for boiler, systems ... - AOL

    www.aol.com/cost-estimates-come-back-boiler...

    Nov. 21—The replacement of mechanical systems at three schools in the district is estimated to cost about $3.96 million, engineers with ISG Inc. presented to the Albert Lea school board Monday.

  6. The Ideal Temperature To Set Your Thermostat at This Winter ...

    www.aol.com/finance/ideal-temperature-set...

    Keeping warm doesn't have to cost you an arm and a leg. Adjusting the thermostat is one way to lower energy costs, but there are other ways to save year-round. See: 10 Frugal Habits To Adopt Right...

  7. Coefficient of performance - Wikipedia

    en.wikipedia.org/wiki/Coefficient_of_performance

    The heat pump itself can be improved by increasing the size of the internal heat exchangers, which in turn increases the efficiency (and the cost) relative to the power of the compressor, and also by reducing the system's internal temperature gap over the compressor. Obviously, this latter measure makes some heat pumps unsuitable to produce ...

  8. Pinch analysis - Wikipedia

    en.wikipedia.org/wiki/Pinch_analysis

    In order to reduce capital cost, in practice a minimum temperature difference (Δ T) at the pinch point is demanded, e.g., 10 °F. It is possible to estimate the heat exchanger area and capital cost, and hence the optimal Δ T minimum value. However, the cost curve is quite flat and the optimum may be affected by "topology traps".

  9. Furnace (central heating) - Wikipedia

    en.wikipedia.org/wiki/Furnace_(central_heating)

    In some areas electrical resistance heating is used, especially where the cost of electricity is low or the primary purpose is for air conditioning. Modern high-efficiency furnaces can be up to 98% efficient and operate without a chimney, with a typical gas furnace being about 80% efficient. [ 1 ]

  1. Ad

    related to: best economy temperature for boiler repair costs