Ads
related to: purpose of throttle position sensor
Search results
Results From The WOW.Com Content Network
The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle. More advanced forms of the sensor are also used. For example, an extra "closed throttle position sensor" (CTPS) may be employed to indicate that the throttle is completely closed. Some engine control units (ECUs) also ...
The throttle position sensor(s) are continually read and then the software makes appropriate adjustments to reach the desired amount of engine power. There are two primary types of Throttle Position Sensor (TPS): a potentiometer or a non-contact sensor Hall Effect sensor (magnetic device).
This is still present in most transmissions though is no longer necessary to use in most circumstances because the TCU uses the throttle position sensor, the rate of change, and driver characteristics to determine whether a downshift may be necessary, thus eliminating the traditional need for this switch.
Often a throttle position sensor (TPS) is connected to the shaft of the throttle plate to provide the ECU with information on whether the throttle is in the idle position, wide-open throttle (WOT) position, or somewhere in between these extremes. Throttle bodies may also contain valves and adjustments to control the minimum airflow during idle.
Delco ECU used in General Motors vehicles built in 1996. An engine control unit (ECU), also called an engine control module (ECM), [1] is a device that controls various subsystems of an internal combustion engine.
The throttle, which controls fuel and air supply to the engine and is also known as the "accelerator" or "gas pedal", is normally the right-most floor pedal. It has a fail-safe design – a spring, which returns it to the idle position when not depressed by the driver.
The predecessor of modern electronic traction control systems can be found in high-torque, high-power rear-wheel-drive cars as a limited slip differential.A limited-slip differential is a purely mechanical system that transfers a relatively small amount of power to the non-slipping wheel, while still allowing some wheel spin to occur.
The AMC "cruise command" unit was actuated through a push-button on the dashboard once the car's desired speed was reached. The throttle position was automatically adjusted by a vacuum control that opened and closed the throttle based on input from the speedometer cable rather than through an adjustable control on the dashboard.