Search results
Results From The WOW.Com Content Network
Pressure in cylinder pattern in dependence on ignition timing: (a) - misfire, (b) too soon, (c) optimal, (d) too late. In a spark ignition internal combustion engine, ignition timing is the timing, relative to the current piston position and crankshaft angle, of the release of a spark in the combustion chamber near the end of the compression stroke.
The differing weight placed on the tires by the front and rear axles causes uneven wear. With the majority of cars having the engine in front, the front tires typically bear more weight than the rear tires. Front-wheel drive vehicles have not only the engine but also the transaxle in front, adding to the weight difference. Moreover, additional ...
Tire fires are events that involve the combustion of large quantities of tires, usually waste tires, typically in locations where they are stored, dumped, or processed. They exist in two forms: as fast-burning events, leading to almost immediate loss of control, and as slow-burning pyrolysis which can continue for over a decade.
These engines can either be full-time lean-burn, where the engine runs with a weak air–fuel mixture regardless of load and engine speed, or part-time lean-burn (also known as "lean mix" or "mixed lean"), where the engine runs lean only during low load and at high engine speeds, reverting to a stoichiometric air–fuel mixture in other cases.
In spark-ignition internal combustion engines, knocking (also knock, detonation, spark knock, pinging or pinking) occurs when combustion of some of the air/fuel mixture in the cylinder does not result from propagation of the flame front ignited by the spark plug, but when one or more pockets of air/fuel mixture explode outside the envelope of the normal combustion front.
Vehicles typically carry a spare tire, already mounted on a wheel rim, to be used in the event of a flat tire or blowout.Spare tires (sometimes called "doughnuts") for modern cars are smaller than regular tires (to save trunk space, weight and cost) and should not be used to drive very far before replacement with a full-size tire.
These limiters may also retard the ignition timing. If using a soft-cut rev limiter, the engine will start to cut fuel or retard ignition timing before the set RPM until it slowly reaches it and remains there. If the engine over-revs anyway, a soft-cut limiter may progressively shut off each cylinder one by one until engine RPMs drop to safe ...
Tires with large unbalances are downgraded or rejected. When tires are fitted to wheels at the point of sale, they are measured again on a balancing machine, and correction weights are applied to counteract their combined unbalance. Tires may be rebalanced if driver perceives excessive vibration. Tire balancing is distinct from wheel alignment.