Search results
Results From The WOW.Com Content Network
The punch; The intermediate rod (tumbler) The hammer (hammer mass) The hammer mass is spring-loaded from the back of the punch by a large spring. (The spring's preload compression can usually be adjusted by loosening or tightening the end cap at the back-most portion of the punch, to decrease or increase the force of the punch.)
Also, in 2001, the CROC North-West branch was opened in St. Petersburg, [5] and later, in 2004, another CROC Ural branch was launched in Yekaterinburg. [6] Thus, CROC has been one of the largest national IT service providers since the early 2000s. [7] In 2005, CROC proceeded with the creation and support of data storage and processing systems. [8]
A turret punch or turret press is a type of punch press used for metal forming by punching. Punching, and press work in general, is a process well suited to mass production. However the initial tooling costs, of both the machine and the job-specific press tool, are high. This limits punch work from being used for much small-volume and prototype ...
It was formed from the Cincinnati Screw and Tap Co., a partnership of George Mueller and Fred Holz, that became more successful building machine tools. [1] From the 1890s through the 1960s, the Cincinnati Milling Machine Company was one of the biggest builders of milling machines. [2] The company became the US's largest machine tool builder by ...
A center punch is used to mark the center of a point. It is usually used to mark the center of a hole when drilling holes. A drill has the tendency to "wander" if it does not start in a recess. A center punch forms a large enough dimple to "guide" the tip of the drill. The tip of a center punch has an angle between 60 and 90 degrees. [1]
Punching is a forming process that uses a punch press to force a tool, called a punch, through the workpiece to create a hole via shearing. Punching is applicable to a wide variety of materials that come in sheet form, including sheet metal, paper, vulcanized fibre and some forms of plastic sheet. The punch often passes through the work into a ...
Older alligator shears were powered by a flywheel.These shears ran continuously, which posed a safety hazard. Now alligator shears are hydraulically actuated.When actuated, the piston arm extends and slowly closes the upper jaw of the alligator shear, which passes alongside the bed or lower jaw of the shear to perform the cut.
The company was founded in 1883 [1] in Chicago as a lumber company by Albert Blake Dick (1856 – 1934). It soon expanded into office supplies and, after licensing key autographic printing patents from Thomas Edison, became the world's largest manufacturer of mimeograph equipment (Albert Dick coined the word "mimeograph"). [3]