Search results
Results From The WOW.Com Content Network
Shotguns intended for defensive use often have cylinder or improved cylinder chokes for the widest shot pattern at typically short defensive ranges; "cylinder barrels" have no constriction. A skeet shooter shooting at close crossing targets might use 0.13 mm (0.005 in) of constriction to produce a 75 cm (30 in) diameter pattern at a distance of ...
The firearm of choice for this task is usually a high-quality, double-barreled over and under shotgun with 24- to 32-inch barrels and very open chokes. Often, shooters will choose an improved cylinder choke (one with a tighter pattern) or a skeet choke (one with a wider pattern), but this is a matter of preference. Some gun shops refer to this ...
The shotgun is available with 12/76mm or 12/89mm chambers and either 610, 650, 710 or 750 mm barrels. The MP-153 is manufactured with fixed choke available as Cylinder, Modified or Full variants, or with screw in chokes with Cylinder, Improved Cylinder, Modified, Improved Modified, Full and Extra Full variants available. Normally there are 3 or ...
The choke tubes were knurled on the outside, but shotgun was also shipped with a wrench to assist with removing the choke tubes. [1] Specs: 3-Shot, Takedown, 20 gauge only (2 1/2 & 2 3/4-inch), 2 shell detachable magazine. Weight 6 1/4 lbs, barrel, 25" with three interchangeable choke tubes, Modified, Full & Improved Cylinder.
SLP shotguns are shipped with a locking device and keys, a Standard Invector improved cylinder and modified choke tubes, a choke tube wrench, two active valve pistons (one for heavy loads and one for light loads), three interchangeable cheekpieces (with Tactical model only), three interchangeable recoil pads (with Tactical model only), and an ...
The Mossberg 500 is a series of pump-action shotguns manufactured by O.F. Mossberg & Sons. [1] The 500 series comprises widely varying models of hammerless repeaters, all of which share the same basic receiver and action, but differ in bore size, barrel length, choke options, magazine capacity, stock and forearm materials.
The Remington 870 was the fourth major design in a series of Remington pump shotguns. John Pedersen designed the fragile Remington Model 10 (and later the improved Remington Model 29). John Browning designed the Remington Model 17 (which was later adapted by Ithaca into the Ithaca 37), which served as the basis for the Remington 31. The Model ...
In 1971, it was offered with the option of the Winchoke screw in choke tube system, supplied with a set of three tubes in improved cylinder (IC), modified (M) and full (F) choke. [15] [f] In 1973, 16-gauge was dropped from the production line. [15] With introduction of the Model 1300, a 3-inch (76 mm) chamber was made standard. [20]