Ad
related to: m12x1.25 end connector dimensions specifications pdf
Search results
Results From The WOW.Com Content Network
Ethernet cable with an M12 X-coded connector in one end and a modular connector in the other. IEC metric screw sized connectors is a family of electrical connectors defined by IEC that are named according to their ISO metric screw thread , namely M5 , M8 and M12 . [ 1 ]
ISO 965 (ISO general purpose metric screw thread—tolerances) is an International Organization for Standardization (ISO) standard for metric screw thread tolerances. [1] It specifies the basic profile for ISO general purpose metric screw threads (M) conforming to ISO 261.
A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25). If the pitch is the normally used "coarse" pitch listed in ISO 261 or ...
The Defense Logistics Agency and General Services Administration maintain Federal Specification W-C-596 [47] and its associated specification sheets. This specification references WD-6 and UL 498, and provides additional durability and electrical safety performance criteria for connectors intended for military use.
The connector systems that are commonly used with Eurocard architectures include the original DIN 41612 connector that is also standardized as IEC 60603.2. This is the connector that is used for the VMEbus standard, which was IEEE 1014. The connector known as the 5-row DIN, which is used for the VME64 Extensions standard is IEC 61076-4-113.
The seal provided by a threaded pipe joint is created when a tapered externally threaded end is tightened into an end with internal threads. For most pipe joints, a good seal requires the application of a separate sealant into the joint, such as thread seal tape , or a liquid or paste pipe sealant such as pipe dope .
The interface dimensions for SMA connectors are listed in MIL-STD-348. [5] The SMA connector employs a 1 ⁄ 4 inch diameter, 36-thread-per-inch threaded barrel. The male is equipped with a hex nut measuring 5 ⁄ 16 inch (0.3125 inch / 7.9 mm) across opposite flats, thus taking the same wrench as a #6 SAE hex nut.
The connector provides power to the keyboard on the outer two contacts and receives data signals on the inner pair. The cable between the computer and the keyboard is a coiled cord with an appearance very similar to a telephone handset cable. [11] The connector on the Amiga 1000 uses crossover wiring, similar to a telephone handset.