When.com Web Search

  1. Ads

    related to: low noise transistor array amplifier for sale near me map

Search results

  1. Results From The WOW.Com Content Network
  2. Low-noise amplifier - Wikipedia

    en.wikipedia.org/wiki/Low-noise_amplifier

    A low-noise amplifier (LNA) is an electronic component that amplifies a very low-power signal without significantly degrading its signal-to-noise ratio (SNR). Any electronic amplifier will increase the power of both the signal and the noise present at its input, but the amplifier will also introduce some additional noise.

  3. Noise figure - Wikipedia

    en.wikipedia.org/wiki/Noise_figure

    The noise power from a simple load is equal to kTB, where k is the Boltzmann constant, T is the absolute temperature of the load (for example a resistor), and B is the measurement bandwidth. This makes the noise figure a useful figure of merit for terrestrial systems, where the antenna effective temperature is usually near the standard 290 K ...

  4. Valve RF amplifier - Wikipedia

    en.wikipedia.org/wiki/Valve_RF_amplifier

    (This is the reason for the relatively high noise resistance of the EF86 in the above example.) Thus, tubes with low noise at high frequency do not necessarily have low noise in the audio frequency range. For special low-noise audio tubes, the frequency at which 1/f noise takes over is reduced as far as possible, maybe to approximately a ...

  5. List of LM-series integrated circuits - Wikipedia

    en.wikipedia.org/wiki/List_of_LM-series...

    Power op-amp with a maximal current output of 3 amperes [23] LM709 Yes General-purpose op-amp [24] LM741 LM709 General-purpose op-amp. [25] Widely used. LM747: Yes General-purpose dual op-amp. [26] LM748 General-purpose op-amp with external compensation [27] LM833 Dual high-speed audio operational amplifiers [28] LM837 Low-noise quadruple op ...

  6. Distributed amplifier - Wikipedia

    en.wikipedia.org/wiki/Distributed_Amplifier

    The design of the distributed amplifiers was first formulated by William S. Percival in 1936. [1] In that year Percival proposed a design by which the transconductances of individual vacuum tubes could be added linearly without lumping their element capacitances at the input and output, thus arriving at a circuit that achieved a gain-bandwidth product greater than that of an individual tube.

  7. Radford Electronics - Wikipedia

    en.wikipedia.org/wiki/Radford_Electronics

    Radford SPA50 transistor power amplifier. Although today, the valve audio amplifiers attract the most attention from enthusiasts, the quality of Radford's designs continued into the transistor age with the "Zero distortion" series of solid state power amplifiers produced in the mid 1970s, in which THD was reduced to less than the circuit noise ...