Search results
Results From The WOW.Com Content Network
In geometry, a set of points in space are coplanar if there exists a geometric plane that contains them all. For example, three points are always coplanar, and if the points are distinct and non-collinear, the plane they determine is unique. However, a set of four or more distinct points will, in general, not lie in a single plane.
In physics, Lami's theorem is an equation relating the magnitudes of three coplanar, concurrent and non-collinear vectors, which keeps an object in static equilibrium, with the angles directly opposite to the corresponding vectors.
Orbital position vector, orbital velocity vector, other orbital elements. In astrodynamics and celestial dynamics, the orbital state vectors (sometimes state vectors) of an orbit are Cartesian vectors of position and velocity that together with their time () uniquely determine the trajectory of the orbiting body in space.
A shearing force is applied to the top of the rectangle while the bottom is held in place. The resulting shear stress, τ, deforms the rectangle into a parallelogram. The area involved would be the top of the parallelogram. Shear stress (often denoted by τ, Greek: tau) is the component of stress coplanar with a material cross section.
For the case of orbital transfer between non-coplanar orbits, the change-of-plane thrust must be made at the point where the orbital planes intersect (the "node"). As the objective is to change the direction of the velocity vector by an angle equal to the angle between the planes, almost all of this thrust should be made when the spacecraft is ...
The diagram shows a Hohmann transfer orbit to bring a spacecraft from a lower circular orbit into a higher one. It is an elliptic orbit that is tangential both to the lower circular orbit the spacecraft is to leave (cyan, labeled 1 on diagram) and the higher circular orbit that it is to reach (red, labeled 3 on diagram).
The coplanar vectors p × L and (mk/r)r are shown in blue and green, respectively; these variables are defined below. The vector A is constant in direction and magnitude. The LRL vector A is defined mathematically by the formula [ 1 ]
In engineering, a parallel force system is a type of force system where in all forces are oriented along one axis. An example of this is a see saw . The children are applying the two forces at the ends, and the fulcrum in the middle gives the counter force to maintain the see saw in neutral position.