Ads
related to: 08200 9007a vs 9007 1 6 gallon toilet flapper installation
Search results
Results From The WOW.Com Content Network
If the toilet is flushed from a tank, a large holding cistern is mounted above the toilet, containing approximately 4.5 to 6 L (1.2 to 1.6 US gallons) of water in modern designs. This tank is built with a large drain 50 to 75 mm (2 to 3 inches) diameter hole at its bottom covered by a flapper valve that allows the water to rapidly leave the ...
Based on the WaterSense averaging rule over two reduced flushes and one full flush, a dual-flush toilet with a full flush at the US legal maximum of 1.6 US gallons (6.1 L) must have a reduced flush of 1.12 US gallons (4.2 L) or less to meet the WaterSense standard of 1.28 US gallons (4.8 L) on average. [17]
A low-flush toilet (or low-flow toilet or high-efficiency toilet) is a flush toilet that uses significantly less water than traditional high-flow toilets. Before the early 1990s in the United States, standard flush toilets typically required at least 3.5 gallons (13.2 litres) per flush and they used float valves that often leaked, increasing their total water use.
When the handle of a flush toilet with a tank (British, cistern) is turned, a discharge mechanism is activated by means of a rod or chain. The mechanism may be a flapper valve, which is designed to sink more slowly than the water - allowing the water to exit to the toilet bowl below, so that the tank may empty.
[1] Thomas Crapper Branding on one of his company's toilets In the 1880s Prince Albert (later Edward VII ) purchased his country seat of Sandringham House in Norfolk and asked Thomas Crapper & Co. to supply the plumbing, including thirty lavatories with cedarwood seats and enclosures, thus giving Crapper his first Royal Warrant .
A Fixture Unit is not a flow rate unit but a design factor. A fixture unit is equal to 1 cubic foot (0.028 m 3) of water drained in a 1 + 1 ⁄ 4 inches (32 mm) diameter pipe over one minute. [2] One cubic foot of water is roughly 7.48 US gallons (28.3 L; 6.23 imp gal). A Fixture Unit is used in plumbing design for both water supply and waste ...