Search results
Results From The WOW.Com Content Network
PN junction operation in forward-bias mode, showing reducing depletion width. In forward bias, the p-type is connected with a positive electrical terminal and the n-type is connected with a negative terminal. The panels show energy band diagram, electric field, and net charge density. The built-in potential of the semiconductor varies ...
Band-bending diagram for p–n diode in forward bias. Diffusion drives carriers across the junction. Quasi-Fermi levels and carrier densities in forward biased p–n-diode. The figure assumes recombination is confined to the regions where majority carrier concentration is near the bulk values, which is not accurate when recombination-generation ...
Current–voltage characteristic of a p–n junction diode showing three regions: breakdown, reverse biased, forward biased. The exponential's "knee" is at V d. The leveling off region which occurs at larger forward currents is not shown. A diode's current–voltage characteristic can be approximated by four operating regions. From lower to ...
The Shockley diode equation, or the diode law, named after transistor co-inventor William Shockley of Bell Labs, models the exponential current–voltage (I–V) relationship of semiconductor diodes in moderate constant current forward bias or reverse bias:
A PN junction in forward bias mode, the depletion width decreases. Both p and n junctions are doped at a 1e15/cm3 doping level, leading to built-in potential of ~0.59V. Observe the different Quasi Fermi levels for conduction band and valence band in n and p regions (red curves). A depletion region forms instantaneously across a p–n junction.
An alternative, which is used for voltage references that need to be highly stable over long periods of time, is to use a Zener diode with a temperature coefficient (TC) of +2 mV/°C (breakdown voltage 6.2–6.3 V) connected in series with a forward-biased silicon diode (or a transistor B–E junction) manufactured on the same chip. [4]
Band diagram for p–n junction at equilibrium. The depletion region is shaded. φ B denotes band shift for holes and charges level. See P–n diode. The inner workings of a light emitting diode, showing circuit (top) and band diagram when a bias voltage is applied (bottom).
If no diode is forward-biased then no diode will provide drive current for the output's load (such as a subsequent logic stage). So the output additionally requires a pull-up or pull-down resistor connected to a voltage source, so that the output can transition quickly [ a ] and provide a strong driving current when no diodes are forward-biased.