When.com Web Search

  1. Ads

    related to: what is a transtube amp made

Search results

  1. Results From The WOW.Com Content Network
  2. Peavey Electronics - Wikipedia

    en.wikipedia.org/wiki/Peavey_Electronics

    Peavey's line of guitar amplifiers made specifically for blues, jazz, and classic rock players. The original Classic series amplifiers were introduced in the 1970s (and were originally called the Peavey 'Vintage' series which the first releases used 6C10 tubes in the pre-amp, NOT solid State. 6C10 amps have a Presence knob, not a Master.

  3. Valve amplifier - Wikipedia

    en.wikipedia.org/wiki/Valve_amplifier

    A valve amplifier or tube amplifier is a type of electronic amplifier that uses vacuum tubes to increase the amplitude or power of a signal. Low to medium power valve amplifiers for frequencies below the microwaves were largely replaced by solid state amplifiers in the 1960s and 1970s.

  4. Valve RF amplifier - Wikipedia

    en.wikipedia.org/wiki/Valve_RF_amplifier

    A valve RF amplifier (UK and Aus.) or tube amplifier is a device for electrically amplifying the power of an electrical radio frequency signal. Low to medium power valve amplifiers for frequencies below the microwaves were largely replaced by solid state amplifiers during the 1960s and 1970s, initially for receivers and low power stages of ...

  5. Trainwreck Circuits - Wikipedia

    en.wikipedia.org/wiki/Trainwreck_Circuits

    All amps are individually made: "it's possible that no two Trainwreck amplifiers actually have the exact same circuit". They are usually equipped with three 12AX7 preamp tubes. [10] Fischer made three kinds of models: Express; two EL34 or two 6V6 output tubes. Two 12AX7 preamp tubes and one 12AX7 phase inverter. (Highest-gain amplifier in the ...

  6. List of valve amplifier designs - Wikipedia

    en.wikipedia.org/wiki/List_of_valve_amplifier...

    The Williamson amplifier was published in 1947 as an article in Wireless World, and was a milestone which defined the mainstream topology for the majority of amplifiers thereafter. The design gave particular attention to a very high specification for the output transformer, in addition to being generally a consistently well worked-through design.

  7. Ampeg - Wikipedia

    en.wikipedia.org/wiki/Ampeg

    The circuit designs of these amplifiers, however, were new. The Portaflex bass amp was reissued, with updates intended to make it more appealing to modern bass players. The Ampeg GVT series, introduced around 2010, is a series of tube amplifiers built in South Korea, employing the Baxandall tone circuit. [27] [jargon]