Ads
related to: ppm to mg per ml conversion table chart search engine free
Search results
Results From The WOW.Com Content Network
Wind speed conversion factors. Meteorological data includes wind speeds which may be expressed as statute miles per hour, knots, or meters per second. Here are the conversion factors for those various expressions of wind speed: 1 m/s = 2.237 statute mile/h = 1.944 knots. 1 knot = 1.151 statute mile/h = 0.514 m/s.
Correcting concentrations for altitude. Air pollutant concentrations expressed as mass per unit volume of atmospheric air (e.g., mg/m 3, μg/m 3, etc.) at sea level will decrease with increasing altitude. The concentration decrease is directly proportional to the pressure decrease with increasing altitude.
Its units are in parts per million (ppm) for gases and in milligrams per cubic meter (mg/m 3) for particulates such as dust, smoke and mist. The basic formula for converting between ppm and mg/m 3 for gases is ppm = (mg/m^3) * 24.45 / molecular weight. This formula is not applicable to airborne particles.
In science and engineering, the parts-per notation is a set of pseudo-units to describe small values of miscellaneous dimensionless quantities, e.g. mole fraction or mass fraction. Since these fractions are quantity-per-quantity measures, they are pure numbers with no associated units of measurement. Commonly used are parts-per-million (ppm, 10 ...
For example, sulfuric acid (H 2 SO 4) is a diprotic acid. Since only 0.5 mol of H 2 SO 4 are needed to neutralize 1 mol of OH −, the equivalence factor is: feq (H 2 SO 4) = 0.5. If the concentration of a sulfuric acid solution is c (H 2 SO 4) = 1 mol/L, then its normality is 2 N. It can also be called a "2 normal" solution.
v. t. e. Saline water (more commonly known as salt water) is water that contains a high concentration of dissolved salts (mainly sodium chloride). On the United States Geological Survey (USGS) salinity scale, saline water is saltier than brackish water, but less salty than brine. The salt concentration is usually expressed in parts per thousand ...
Chemical oxygen demand. In environmental chemistry, the chemical oxygen demand (COD) is an indicative measure of the amount of oxygen that can be consumed by reactions in a measured solution. It is commonly expressed in mass of oxygen consumed over volume of solution, which in SI units is milligrams per liter (mg / L).
Average levels of PM 2.5 were measured using aqicn.org's World Air Quality Index data, and a formula developed by AirNow was used to convert the PM 2.5 figure into micrograms per cubic meter of air ( μg / m 3 ) values. Among the 70 capital cities investigated, Baghdad, Iraq is the worst performing one, with PM 2.5 levels going up +31.6 ...