Search results
Results From The WOW.Com Content Network
Cross bracing between joists or rafters strengthens the members by preventing sideways deflection. This bracing is known by many names such as herringbone strutting, blocking, bridging, and dwanging. Cross bracing on a bridge tower. In construction, cross bracing is a system utilized to reinforce building structures in which diagonal supports ...
Blocking also resists the rotational movement, or twisting, of floor joists as they deflect under load. This may take the form of diagonal cross bracing, or herringbone, bracing between floor joists. When solid blocks are used instead of diagonals it is called bridging, block bridging, solid bridging or solid strutting. The illustration, right ...
This is accomplished by using metal ties fastened to each rafter or truss. This is not normally a problem in areas not prone to high wind or extreme weather conditions. In the UK, a concrete tiled roof would normally have rafters at 600 mm (24 in) centers, roof battens at 300 mm (12 in) centers and ceiling joists at 400 mm (16 in) centers.
A lookout, [1] lookout rafter or roof outlooker [2] is a wooden joist that extends in cantilever out from the exterior wall (or wall plate) of a building, supporting the roof sheathing and providing a nailing surface for the fascia boards. When not exposed it serves to fasten the finish materials of the eaves.
In construction, a dwang (Scotland and New Zealand), [1] [2] [3] nogging piece, nogging, noggin or nog (England and Australia; all derived from brick nog), [4] [5] or blocking (North America), is a horizontal bracing piece used between wall studs to give rigidity to the wall frames of a building. Noggings may be made of timber, steel, or aluminium.
A double floor is a floor framed with joists supported by larger timbers.. In traditional timber framing there may be a single set of joists which carry both a floor and ceiling called a single floor (single joist floor, single framed floor) or two sets of joists, one carrying the floor and another carrying the ceiling called a double floor (double framed floor).
A tie in building construction is an element in tension rather than compression and most collar beams are designed to work in compression to keep the rafters from sagging. [ 2 ] [ 3 ] A collar near the bottom of the rafters may replace a tie beam and be designed to keep the rafters from spreading, thus are in tension: these are correctly called ...
In light-frame construction, a trimmer is a timber or metal beam (joist) used to create an opening around a stairwell, skylight, chimney, and the like. Trimmers are installed parallel to the primary floor or ceiling joists and support headers, which run perpendicular to the primary joists.