Search results
Results From The WOW.Com Content Network
Low Pin Count interface Winbond chip Trusted Platform Module installed on a motherboard, and using the LPC bus. The Low Pin Count (LPC) bus is a computer bus used on IBM-compatible personal computers to connect low-bandwidth devices to the CPU, such as the BIOS ROM (BIOS ROM was moved to the Serial Peripheral Interface (SPI) bus in 2006 [1]), "legacy" I/O devices (integrated into Super I/O ...
PCI express devices commonly use SMBus as a "out-of-band management port". However, device vendors frequently use SMBus multiplexers (Mux) to manage address clashes (which are in turn caused by them not implementing the Address Resolution Protocol), causing link interruptions that break Management Component Transport Protocol and other ...
Typical POST screen (AMI BIOS) Typical UEFI-compliant BIOS POST screen (Phoenix Technologies BIOS) Summary screen after POST and before booting an operating system (AMI BIOS) A power-on self-test ( POST ) is a process performed by firmware or software routines immediately after a computer or other digital electronic device is powered on.
The xHCI reduces the need for periodic device polling by allowing a USB 3.0 or later device to notify the host controller when it has data available to read, and moves the management of polling USB 2.0 and 1.1 devices that use interrupt transactions from the CPU-driven USB driver to the USB host controller.
Peripheral Component Interconnect (PCI) [3] is a local computer bus for attaching hardware devices in a computer and is part of the PCI Local Bus standard. The PCI bus supports the functions found on a processor bus but in a standardized format that is independent of any given processor's native bus.
If no printer port is present at 0x3BC, the second port in the row (0x378) becomes logical parallel port 1 and 0x278 becomes logical parallel port 2 for the BIOS. Sometimes, printer ports are jumpered to share an interrupt despite having their own IO addresses (i.e. only one can be used interrupt-driven at a time).
At a lower level, a device driver implementing these functions would communicate to the particular serial port controller installed on a user's computer. The commands needed to control a 16550 UART are much different from the commands needed to control an FTDI serial port converter, but each hardware-specific device driver abstracts these ...
In computing, a legacy port is a computer port or connector that is considered by some to be fully or partially superseded. [1] The replacement ports usually provide most of the functionality of the legacy ports with higher speeds, more compact design, or plug and play and hot swap capabilities for greater ease of use.