Search results
Results From The WOW.Com Content Network
Schematic diagram of an opto-isolator showing source of light (LED) on the left, dielectric barrier in the center, and sensor (phototransistor) on the right [note 1]. An opto-isolator (also called an optocoupler, photocoupler, or optical isolator) is an electronic component that transfers electrical signals between two isolated circuits by using light. [1]
A film scanner scans original film stock: negative or positive print or reversal/IP. Units may scan gauges from 8 mm to 70 mm (8 mm, Super 8, 9.5 mm, 16 mm, Super 16, 35 mm, Super 35, 65 mm and 70 mm) with very high resolution scanning at 2K, 4K, 8K, or 16K resolutions. (2K is approximately 2048×1080 pixels and 4K is approximately 4096×2160 ...
Opto-isolator VTL2C1 with LED input and photoresistor output. Resistive opto-isolator (RO), also called photoresistive opto-isolator, vactrol (after a genericized trademark introduced by Vactec, Inc. in the 1960s), analog opto-isolator [notes 1] or lamp-coupled photocell, [1] is an optoelectronic device consisting of a source and detector of light, which are optically coupled and electrically ...
Laser scanning is the controlled deflection of laser beams, visible or invisible. [1] Scanned laser beams are used in some 3-D printers, in rapid prototyping, in machines for material processing, in laser engraving machines, in ophthalmological laser systems for the treatment of presbyopia, in confocal microscopy, in laser printers, in laser shows, in Laser TV, and in barcode scanners.
The CAS code shows this is (top row) ISO 125 film, (bottom row) 24 exposures, +3/−1 f-stop exposure tolerance. The DX barcode reads 017563, showing DX number 109-12, 24 exposures. DX ( D igital inde X ) encoding is a standard for marking 35 mm and APS photographic film and film cartridges, originally introduced by Kodak in 1983.
A dielectric output-coupler for a dye laser. Centered at 550 nm, the left photo shows its high reflectance to yellow light and its high transmittance to red and blue light. The right photo shows it reflecting 75% of a laser beam and transmitting 25%, although the beam appears brighter when moving toward the observer than when moving away.
For the Agfa film assigned DX number 115-4 above, the hashed 4-digit code would be 1844: 16 × 115 + 4 = 1844 {\displaystyle 16\times 115+4=1844} The DX number can be recovered from the hashed code by dividing by 16, which gives the Part 1 number as the largest whole integer and the Part 2 number as the remainder:
The photon of an incident laser pulse (pump) is, by a nonlinear optical crystal, divided into two lower-energy photons. The wavelengths of the signal and the idler are determined by the phase matching condition, which is changed, e.g. by temperature or, in bulk optics, by the angle between the incident pump laser ray and the optical axes of the ...