Search results
Results From The WOW.Com Content Network
When UI is used as a measurement unit of a time interval, the resulting measure of such time interval is dimensionless. It expresses the time interval in terms of UI. Very often, but not always, the UI coincides with the bit time, i.e. with the time interval taken to transmit one bit (binary information digit).
Jitter is a significant, and usually undesired, factor in the design of almost all communications links. Jitter can be quantified in the same terms as all time-varying signals, e.g., root mean square (RMS), or peak-to-peak displacement. Also, like other time-varying signals, jitter can be expressed in terms of spectral density.
Each time the peak-to-peak distance between the largest and smallest TIE in that window is noted. This distance varies as the window moves, being maximal for some window position. This maximal distance is known as MTIE for the given observation interval.
Jitter is the undesired deviation from true periodicity of an assumed periodic signal in electronics and telecommunications, often in relation to a reference clock source. Jitter may be observed in characteristics such as the frequency of successive pulses, the signal amplitude , or phase of periodic signals.
This of course means that the clock skew between two points varies from cycle to cycle, which is a complexity that is rarely mentioned. Many other authors use the term clock skew only for the spatial variation of clock times, and use the term clock jitter to represent the rest of the total clock timing uncertainty. This of course means that the ...
The round-trip time or ping time is the time from the start of the transmission from the sending node until a response (for example an ACK packet or ping ICMP response) is received at the same node. It is affected by packet delivery time as well as the data processing delay , which depends on the load on the responding node.
The counter implementation's accuracy is limited by the clock frequency. If time is measured by whole counts, then the resolution is limited to the clock period. For example, a 10 MHz clock has a resolution of 100 ns. To get resolution finer than a clock period, there are time interpolation circuits. [6]
Clock synchronization is a topic in computer science and engineering that aims to coordinate otherwise independent clocks. Even when initially set accurately, real clocks will differ after some amount of time due to clock drift, caused by clocks counting time at slightly different rates. There are several problems that occur as a result of ...