Search results
Results From The WOW.Com Content Network
Token Ring is a physical and data link layer computer networking technology used to build local area networks. It was introduced by IBM in 1984, and standardized in 1989 as IEEE 802.5. It uses a special three-byte frame called a token that is passed around a logical ring of workstations or servers.
A ring network is a network topology in which each node connects to exactly two other nodes, forming a single continuous pathway for signals through each node – a ring. Data travels from node to node, with each node along the way handling every packet.
A double DIN 1.6/5.6 bulkhead jack connector, crimp type, for 75 Ω coaxial cable A Type N connector (male), right-angled solder-type for semi-rigid coaxial cable with a diameter of 0.141-inch. 4.1-9.5 connector, standardized as DIN 47231 (in 1974) and IEC 60169-11 (in 1977) 4.3-10 connector, formerly known as DIN 4.3/10, now standardized as ...
Ring network topology. A ring topology is a daisy chain in a closed loop. Data travels around the ring in one direction. When one node sends data to another, the data passes through each intermediate node on the ring until it reaches its destination. The intermediate nodes repeat (retransmit) the data to keep the signal strong. [5]
The 4.3-10 connector (sometimes referred to as 4.3/10) is a 50 Ω multi-purpose RF connector used to connect coaxial cables with other cables or RF devices, such as transmitters or antennas. The IEC standard 61169-54 specifies an inner diameter of the outer conductor is 10 mm and the outer diameter of the inner conductor is 4.3 mm.
Some extended performance versions are rated to 10 GHz. The normally free part (a.k.a. plug) of a SMC connector that has a socket for the centre contact are the female connectors. The normally fixed part (a.k.a. jack) SMC connectors that has a pin for the centre contact are the male connectors. This is the reverse of most RF connectors.
6P4C crimp-on style connector, commonly used for RJ11 and unpowered RJ14 The most widely implemented registered jack in telecommunications is the RJ11. This is a modular connector wired for one telephone line, using the center two contacts of six available positions.
The pin arrangement for a 10P10C socket A 10P10C plug. The 10P10C connector is commonly referred to as an RJ50 connector, [25] although this was never a standard registered jack. The 10P10C has 10 contact positions and 10 contacts. The most common uses of the 10P10C connector are in proprietary data transfer systems. [26]