Ads
related to: led battery level indicator circuit using lm3914 and driver manual
Search results
Results From The WOW.Com Content Network
LM3914 driving an LED bargraph display LM3915 IC in DIP-18 package. The LM3914 is an integrated circuit (IC), designed by National Semiconductor in the late 1970s, used to operate displays that visually show the magnitude of an analog signal. [1] It can drive up to 10 LEDs, LCDs, or vacuum fluorescent displays on its outputs. The linear scaling ...
The following is a list of LM-series integrated circuits. Many were among the first analog integrated circuits commercially produced since late 1965; [1] some were groundbreaking innovations [opinion]. As of 2007, many are still being used. [2] The LM series originated with integrated circuits made by National Semiconductor.
In 1969, Hewlett-Packard introduced the HP Model 5082-7000 Numeric Indicator, an early LED display and the first LED device to use integrated circuit technology. Its development was led by Howard C. Borden and Gerald P. Pighini at HP Associates and HP Labs, who had engaged in research and development (R&D) on practical LEDs between 1962 and ...
In battery types where EMF remains approximately constant during discharge, but resistance increases, voltage across battery terminals is not a good indicator of capacity. A meter such as an equivalent series resistance meter ( ESR meter ) normally used for measuring the ESR of electrolytic capacitors can be used to evaluate internal resistance ...
Current mode logic (CML), or source-coupled logic (SCL), is a digital design style used both for logic gates and for board-level digital signaling of digital data.. The basic principle of CML is that current from a constant current generator is steered between two alternate paths depending on whether a logic zero or logic one is being represented.
Entry-level cable testers are essentially continuity testers. A continuity tester is an item of electrical test equipment used to determine if an electrical path can be established between two points; [1] that is if an electrical circuit can be made. The circuit under test is completely de-energized prior to connecting the apparatus. [1]
Typically the driver stage(s) of a circuit requires different characteristics to other circuit stages. For example, in a transistor power amplifier circuit, typically the driver circuit requires current gain, often the ability to discharge the following transistor bases rapidly, and low output impedance to avoid or minimize distortion.
Schematic diagram of an opto-isolator showing source of light (LED) on the left, dielectric barrier in the center, and sensor (phototransistor) on the right [note 1]. An opto-isolator (also called an optocoupler, photocoupler, or optical isolator) is an electronic component that transfers electrical signals between two isolated circuits by using light. [1]