Ads
related to: das kit throttle assembly replacement parts diagram 1 12
Search results
Results From The WOW.Com Content Network
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
This is a list of auto parts, which are manufactured components of automobiles. This list reflects both fossil-fueled cars (using internal combustion engines) and electric vehicles; the list is not exhaustive. Many of these parts are also used on other motor vehicles such as trucks and buses.
In fuel injected engines, the throttle body is the part of the air intake system that controls the amount of air flowing into the engine, in response to driver accelerator pedal input in the main. The throttle body is usually located between the air filter box and the intake manifold, and it is usually attached to, or near, the mass airflow sensor.
Non contact type TPS work on the principle of Hall effect or inductive sensors, or magnetoresistive technologies, wherein generally the magnet or inductive loop is the dynamic part which is mounted on the butterfly valve throttle spindle/shaft gear and the sensor & signal processing circuit board is mounted within the ETC gear box cover and is ...
The result is an engine that fails to maintain idle RPM and frequently stalls. A jammed actuator may be freed simply by cleaning it. However an actuator that has stopped working due to a fault in its servomotor will need replacement. Air leaks in either the stepper housing or pipes will cause elevated idle RPM.
The part number on the harmonic balancer pulley can be compared to those given to Mercedes-Benz dealers in the Service Campaign notice [30] to determine if the part is a faulty original or has been replaced with the updated part. Replacement of the faulty part with the updated part should be a permanent solution to this problem.
Early cars had a hand lever to control the throttle, either directly, or by controlling an engine speed governor which in turn controlled both the throttle and timing. [6] In 1900 the Wilson-Pilcher car was introduced in Britain which had a hand controlled speed governor, and a foot throttle which could override the action of the governor.
Thrust levers in a Boeing 747 Classic. The center and rear levers are used during flight, while the forward levers control reverse thrust.. Thrust levers or throttle levers are found in the cockpit of aircraft, and are used by the pilot, copilot, flight engineer, or autopilot to control the thrust output of the aircraft's engines, by controlling the fuel flow to those engines. [1]