Search results
Results From The WOW.Com Content Network
Michigan O probe with Williams markings (left) and Naber's probe with shades alternating every 3 mm (right). Proper use of the periodontal probe is necessary to maintain accuracy. The tip of the instrument is placed with light pressure of 10-20 grams [ 1 ] into the gingival sulcus , which is an area of potential space between a tooth and the ...
A probe tip is an instrument used in scanning probe microscopes (SPMs) to scan the surface of a sample and make nano-scale images of surfaces and structures. The probe tip is mounted on the end of a cantilever and can be as sharp as a single atom .
Double-ended probe: used for probing Tongue tie: to tie away the tongue so that it doesn't fall back into the pharynx. Formaldehyde: primary preservative for Anatomy; video link: saturated Common salt solution / Rectified spirit: primary preservative for Autopsy; video link. Osteometric board: to measure the length of (usually dried) bones X ...
[12] [failed verification] These probes are also called resistive divider probes, since a 50 ohm transmission line presents a purely resistive load. The Z 0 name refers to the characteristic impedance of the oscilloscope and cable. The matched impedances provide better high-frequency performance than an unmatched passive probe can achieve, but ...
A multimeter can use many different test probes to connect to the circuit or device under test. Crocodile clips, retractable hook clips, and pointed probes are the three most common types. Tweezer probes are used for closely spaced test points, as for instance surface-mount devices. The connectors are attached to flexible, well insulated leads ...
to draw or drain out all the blood before replacing it with embalming fluids like formaldehyde for preservation of structures as practiced in Anatomy: Head rest: to elevate the head Ropes: to tie the corpse in places so that it does not change posture during dissection Rubber gloves: protective; video link: Goggles: protective; video link ...
This is generally required in order to provide a means of applying a bias to the sample, and can be achieved through manufacturing standard silicon probes and coating them in a conductive material. Common coatings are platinum, gold, tungsten and even conductive diamond. Scanning electron microscopy images of a PtIr 5 coated scanning probe ...
Larger-diameter platinum wire is used, which drives up the cost and results in a lower resistance for the probe (typically 25.5 Ω). UPRTs have a wide temperature range (−200 °C to 1000 °C) and are approximately accurate to ±0.001 °C over the temperature range. UPRTs are only appropriate for laboratory use.