Search results
Results From The WOW.Com Content Network
A governor, or speed limiter or controller, is a device used to measure and regulate the speed of a machine, such as an engine.. A classic example is the centrifugal governor, also known as the Watt or fly-ball governor on a reciprocating steam engine, which uses the effect of inertial force on rotating weights driven by the machine output shaft to regulate its speed by altering the input flow ...
Three-deck rotary switch allows controlling three different circuit functions. A rotary switch is a switch operated by rotation. These are often chosen when more than 2 positions are needed, such as a three-speed fan or a CB radio with multiple frequencies of reception or "channels".
An electronic speed control follows a speed reference signal (derived from a throttle lever, joystick, or other manual input) and varies the switching rate of a network of field effect transistors (FETs). [1] By adjusting the duty cycle or switching frequency of the transistors, the speed of the motor is changed. The rapid switching of the ...
An electronic control unit (ECU), also known as an electronic control module (ECM), is an embedded system in automotive electronics that controls one or more of the electrical systems or subsystems in a car or other motor vehicle.
The balls swing out as speed increases, which closes the valve, until a balance is achieved between demand and the proportional gain of the linkage and valve. A centrifugal governor is a specific type of governor with a feedback system that controls the speed of an engine by regulating the flow of fuel or working fluid , so as to maintain a ...
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
Cruise control (also known as speed control, cruise command, autocruise, or tempomat) is a system that automatically controls the speed of an automobile. The system is a servomechanism that takes over the car's throttle to maintain a steady speed set by the driver.
This can be used either to produce continuous rotation at a controlled speed or to move by a controlled angular amount. If the stepper is combined with either a position encoder or at least a single datum sensor at the zero position, it is possible to move the motor to any angular position and so to act as a rotary actuator.