Search results
Results From The WOW.Com Content Network
A host of functions required for ECU software calibration, such as interface-dependent calibration methods, calibration data management, measurement data visualization and analysis, ECU programming, vehicle bus monitoring, as well as remote control through standard interfaces, are part of the product's functional complement.
Keeping the resistance of wiring and the spreading resistance within the probe tips to a minimum, the measured resistance is almost exclusively from = for silicon samples at least thick. With the aid of calibration resistivity standards, ρ {\displaystyle \rho } can be determined at each probing by the probe pair.
Argus – the Audit Record Generation and Utilization System is the first implementation of network flow monitoring, and is an ongoing open source network flow monitor project. Started by Carter Bullard in 1984 at Georgia Tech, and developed for cyber security at Carnegie Mellon University in the early 1990s, Argus has been an important ...
The van der Pauw Method is a technique commonly used to measure the resistivity and the Hall coefficient of a sample. Its strength lies in its ability to accurately measure the properties of a sample of any arbitrary shape, as long as the sample is approximately two-dimensional (i.e. it is much thinner than it is wide), solid (no holes), and the electrodes are placed on its perimeter.
Four-point measurement of resistance between voltage sense connections 2 and 3. Current is supplied via force connections 1 and 4. In electrical engineering, four-terminal sensing (4T sensing), 4-wire sensing, or 4-point probes method is an electrical impedance measuring technique that uses separate pairs of current-carrying and voltage-sensing electrodes to make more accurate measurements ...
A passive oscilloscope probe with a switch in the probe handle that selects 1× or 10× attenuation. To minimize loading, attenuator probes (e.g., 10× probes) are used. A typical probe uses a 9 megohm series resistor shunted by a low-value capacitor to make an RC compensated divider with the cable capacitance and scope input.
The probe is the spherical part, 50 mm in diameter and made from titanium with a surface coating of titanium nitride. A Langmuir probe is a device used to determine the electron temperature, electron density, and electric potential of a plasma. It works by inserting one or more electrodes into a plasma, with a constant or time-varying electric ...
Hall effect magnetometers (also called tesla meters or gauss meters) use a Hall probe [23] with a Hall element to measure magnetic fields or inspect materials (such as tubing or pipelines) using the principles of magnetic flux leakage. A Hall probe is a device that uses a calibrated Hall effect sensor to directly measure the strength of a ...