Ad
related to: check ram frequency windows 11 laptop amazon
Search results
Results From The WOW.Com Content Network
For example, DDR3-2000 memory has a 1000 MHz clock frequency, which yields a 1 ns clock cycle. With this 1 ns clock, a CAS latency of 7 gives an absolute CAS latency of 7 ns. Faster DDR3-2666 memory (with a 1333 MHz clock, or 0.75 ns exactly; the 1333 is rounded) may have a larger CAS latency of 9, but at a clock frequency of 1333 MHz the ...
Memory clock then determines the final operating frequency or effective clock speed of memory system depending upon DRAM types (DDR, DDR2 and DDR3 SDRAM). By default, FSB speed and memory are usually set to a 1:1 ratio, meaning that increasing FSB speed (by overclocking) increases memory speed by the same amount. Normally system memory is not ...
In computing, serial presence detect (SPD) is a standardized way to automatically access information about a memory module.Earlier 72-pin SIMMs included five pins that provided five bits of parallel presence detect (PPD) data, but the 168-pin DIMM standard changed to a serial presence detect to encode more information.
Rambus announced a working DDR5 dual in-line memory module (DIMM) in September 2017. [9] [10] On November 15, 2018, SK Hynix announced completion of its first DDR5 RAM chip; running at 5.2 GT/s at 1.1 V. [11] In February 2019, SK Hynix announced a 6.4 GT/s chip, the highest speed specified by the preliminary DDR5 standard. [12]
The memory bus connects the northbridge and RAM, just as the front-side bus connects the CPU and northbridge. Often, these two buses must operate at the same frequency. Increasing the front-side bus to 450 MHz in most cases also means running the memory at 450 MHz. In newer systems, it is possible to see memory ratios of "4:5" and the like.
The CAS latency is the delay between the time at which the column address and the column address strobe signal are presented to the memory module and the time at which the corresponding data is made available by the memory module. The desired row must already be active; if it is not, additional time is required.
With data being transferred 64 bits at a time, DDR SDRAM gives a transfer rate (in bytes/s) of (memory bus clock rate) × 2 (for dual rate) × 64 (number of bits transferred) / 8 (number of bits/byte). Thus, with a bus frequency of 100 MHz, DDR SDRAM gives a maximum transfer rate of 1600 MB/s.
The lower memory clock frequency may also enable power reductions in applications that do not require the highest available data rates. According to JEDEC [5] the maximum recommended voltage is 1.9 volts and should be considered the absolute maximum when memory stability is an issue (such as in servers or other mission critical devices). In ...