Search results
Results From The WOW.Com Content Network
In a CRT, the vertical scan rate is the number of times per second that the electron beam returns to the upper left corner of the screen to begin drawing a new frame. [3] It is controlled by the vertical blanking signal generated by the video controller, and is partially limited by the monitor's maximum horizontal scan rate.
Horizontal scan rate, or horizontal frequency, usually expressed in kilohertz, is the number of times per second that a raster-scan video system transmits or displays a complete horizontal line, as opposed to vertical scan rate, the number of times per second that an entire screenful of image data is transmitted or displayed.
In a 100 Hz/120 Hz analog TV, there is a scan converter circuit which converts the vertical frequency (refresh rate) from standard 50/60 Hz to 100/120 Hz to achieve a low level of flicker which is important in large screen (high inch) TVs. An external TV card receives the TV signals and converts them to VGA or SVGA format to display on monitor.
Scan rate is a term used when discussing raster-scan video, describing the speed at which the image is transmitted or displayed. There are two types: There are two types: Horizontal scan rate , the number of times per second that a single horizontal line of image data is transmitted or displayed
In revision 1.2, released in 2013, a new "Reduced Blanking Timing Version 2" mode was added which further reduces the horizontal blanking interval from 160 to 80 pixels, increases pixel clock precision from ±0.25 MHz to ±0.001 MHz, and adds the option for a 1000/1001 modifier for ATSC/NTSC video-optimized timing modes (e.g. 59.94 Hz instead ...
In NTSC-system countries, the TV scan rate of 30 frame/s would cause a perceptible speedup if the same were attempted, and the necessary correction is performed by a technique called 3:2 pulldown: Over each successive pair of film frames, one is held for three video fields (1/20 of a second) and the next is held for two video fields (1/30 of a ...
Overscan is a behaviour in certain television sets in which part of the input picture is cut off by the visible bounds of the screen. It exists because cathode-ray tube (CRT) television sets from the 1930s to the early 2000s were highly variable in how the video image was positioned within the borders of the screen.
The basis for this otherwise odd seeming resolution is similar to that of other "wide" standards – the line scan (refresh) rate of the well-established "XGA" standard (1024 × 768 pixels, 4:3 aspect ratio) extended to give square pixels on the increasingly popular 16:9 widescreen display ratio without having to effect major signalling changes ...