Search results
Results From The WOW.Com Content Network
There are two groups of system code pages in Windows systems: OEM and Windows-native ("ANSI") code pages. (ANSI is the American National Standards Institute.) Code pages in both of these groups are extended ASCII code pages. Additional code pages are supported by standard Windows conversion routines, but not used as either type of system code page.
The PDP-6 monitor, [38] and its PDP-10 successor TOPS-10, [39] used control-Z (SUB) as an end-of-file indication for input from a terminal. Some operating systems such as CP/M tracked file length only in units of disk blocks, and used control-Z to mark the end of the actual text in the file. [ 49 ]
In 1973, ECMA-35 and ISO 2022 [18] attempted to define a method so an 8-bit "extended ASCII" code could be converted to a corresponding 7-bit code, and vice versa. [19] In a 7-bit environment, the Shift Out would change the meaning of the 96 bytes 0x20 through 0x7F [a] [21] (i.e. all but the C0 control codes), to be the characters that an 8-bit environment would print if it used the same code ...
The interpretation of the control key with non-ASCII ("foreign") keys also varies between systems. Control characters are often rendered into a printable form known as caret notation by printing a caret (^) and then the ASCII character that has a value of the control character plus 64. Control characters generated using letter keys are thus ...
Even though Windows-1252 was the first and by far most popular code page named so in Microsoft Windows parlance, the code page has never been an ANSI standard. Microsoft explains, "The term ANSI as used to signify Windows code pages is a historical reference, but is nowadays a misnomer that continues to persist in the Windows community." [10]
The Basic Latin Unicode block, [3] sometimes informally called C0 Controls and Basic Latin, [4] is the first block of the Unicode standard, and the only block which is encoded in one byte in UTF-8. The block contains all the letters and control codes of the ASCII encoding.
For the control-codes outside of the range 1–26, the notation extends to the adjacent, non-alphabetic ASCII characters. Often a control character can be typed on a keyboard by holding down the Ctrl and typing the character shown after the caret. The notation is often used to describe keyboard shortcuts even though the control character is not ...
The tool is usually useful for entering special characters. [1] It can be opened via the command-line interface or Run command dialog using the 'charmap' command.. The "Advanced view" check box can be used to inspect the character sets in a font according to different encodings (), including Unicode code ranges, to locate particular characters by their Unicode code point and to search for ...