Ads
related to: atx power connector 20 pin cable- Cat6 Patch Cables
Quantity Discounts as low as $2.13
All Colors and Lengths.
- HDMI Cables
High Speed & Enhanced Ethernet.
Offered in 1ft-65ft Options.
- USB Cables
USB 2.0, Printer Cables, Micro USB
High Quality USB Cables & Devices.
- Bulk Cable
Buy network, telephone, coax, audio
& video cables and wire in bulk!
- Network Cables
Custom Lengths and Colors
In Stock. Same Day Shipping!
- F Patch Cables
Get quantity discount pricing on
F patch cables. Up to 250+!
- Cat6 Patch Cables
amazon.com has been visited by 1M+ users in the past month
Search results
Results From The WOW.Com Content Network
An ATX power supply provides a number of peripheral power connectors and (in modern systems) two connectors for the motherboard: an 8-pin (or 4+4-pin) auxiliary connector providing additional power to the CPU and a main 24-pin power supply connector, an extension of the original 20-pin version. 20-pin Molex 39-29-9202 at the motherboard. 20-pin ...
PS-ON Signal is a pin on a 20-pin or 24-pin ATX-specified power connector used to turn a personal computer power supply unit on/off. The PS_ON pin is normally pulled high in an open-circuit, but will turn on the power supply when it is pulled low, by shorting it to the common signal (COM). Conversely the power supply is turned off when the PS ...
ATX motherboard power connector (usually called P1): This is the connector that goes to the motherboard to provide it with power. The connector has 20 or 24 pins. One of the pins belongs to the PS-ON wire (it is usually green). This connector is the largest of all the connectors. In older AT power supplies, this connector was split in two: P8 ...
These supplied +5V, +12V, −5V, −12V, "power-good signal", and ground. The most notable difference from modern 20/24-pin ATX power connectors is that the AT power supply connector did not have a signal to turn on the power supply, and also did not supply separate, "always-on" +5V standby power.
The power connector on the 3½-inch floppy drive, informally known as "the Berg connector", is 2.50 mm pitch (distance from center to center of pins). The power cable from the ATX power supply consists of 20 AWG wire to a 4-pin female connector. [ 1 ]
The ATX specification requires that the power-good signal ("PWR_OK") go high no sooner than 100 ms after the power rails have stabilized, and remain high for 16 ms after loss of AC power, and fall (to less than 0.4 V) at least 1 ms before the power rails fall out of specification (to 95% of their nominal value).
Ads
related to: atx power connector 20 pin cableamazon.com has been visited by 1M+ users in the past month