When.com Web Search

  1. Ads

    related to: freewheel mechanics set 1000 lbs value 2 4 ton

Search results

  1. Results From The WOW.Com Content Network
  2. Rolling resistance - Wikipedia

    en.wikipedia.org/wiki/Rolling_resistance

    But, if the inflation pressure is not changed, then a 20% increase in load results in a 4% increase in Crr. Of course, this will increase the rolling resistance by 20% due to the increase in load plus 1.2 x 4% due to the increase in Crr resulting in a 24.8% increase in rolling resistance. [53]

  3. Power-to-weight ratio - Wikipedia

    en.wikipedia.org/wiki/Power-to-weight_ratio

    Power-to-weight is often quoted by manufacturers at the peak value, but the actual value may vary in use and variations will affect performance. The inverse of power-to-weight, weight-to-power ratio (power loading) is a calculation commonly applied to aircraft, cars, and vehicles in general, to enable the comparison of one vehicle's performance ...

  4. Freewheel - Wikipedia

    en.wikipedia.org/wiki/Freewheel

    A freewheel was also used in the original Land Rover vehicle from 1948 to 1951. The freewheel controlled drive from the gearbox to the front axle, which disengaged on the overrun. This allowed the vehicle to have a permanent 4 wheel drive system by avoiding 'wind-up' forces in the transmission. This system worked, but produced unpredictable ...

  5. Flywheel energy storage - Wikipedia

    en.wikipedia.org/wiki/Flywheel_energy_storage

    NASA G2 flywheel. Flywheel energy storage (FES) works by accelerating a rotor to a very high speed and maintaining the energy in the system as rotational energy.When energy is extracted from the system, the flywheel's rotational speed is reduced as a consequence of the principle of conservation of energy; adding energy to the system correspondingly results in an increase in the speed of the ...

  6. Chevrolet C/K (first generation) - Wikipedia

    en.wikipedia.org/wiki/Chevrolet_C/K_(first...

    1961 Chevrolet Apache C10. The first-generation C/K trucks are built using body-on-frame construction. Diverging from light truck design precedent, the C/K ended its use of straight frame rails, adopting a drop-center design; 1 ⁄ 2-ton and 3 ⁄ 4-ton trucks used a hybrid of an X-frame and perimeter-frame layout, while 1-ton trucks used a drop-center ladder frame.

  7. Pelton wheel - Wikipedia

    en.wikipedia.org/wiki/Pelton_wheel

    The Pelton wheel or Pelton Turbine is an impulse -type water turbine invented by American inventor Lester Allan Pelton in the 1870s. [ 1 ][ 2 ] The Pelton wheel extracts energy from the impulse of moving water, as opposed to water's dead weight like the traditional overshot water wheel. Many earlier variations of impulse turbines existed, but ...