Search results
Results From The WOW.Com Content Network
In effect, this means that both push-rod and pull-rod systems are functionally the same design. [5] [6] In a push-rod suspension system, there is an upper and lower control arm, similar in design to a double-wishbone frame, which provide a structurally integral connection between the wheel hubs and the chassis.
Double wishbone suspension; arms and knuckle painted yellow. In automobiles, a double wishbone suspension is an independent suspension design using two (occasionally parallel) wishbone-shaped arms to locate the wheel. Each wishbone or arm has two mounting points to the chassis and one joint at the knuckle.
The double-wishbone suspension can also be referred to as ‘double A-arm,’ though the arms themselves can be A-shaped, L-shaped, or even a single bar linkage. The complete TAK-4 independent suspension system set-up also includes a subframe which contains the axle differential, half shafts, and wheel ends with steering attachments and brakes.
Double wishbone suspension (front) on a Saab Quantum IV. The double-wishbone suspension can also be referred to as "double A-arms", though the arms themselves can be A-shaped or L-shaped. A single wishbone or A-arm can also be used in various other suspension types, such as variations of the MacPherson strut.
Automotive suspension design is an aspect of automotive engineering, concerned with designing the suspension for cars and trucks. Suspension design for other vehicles is similar, though the process may not be as well established. The process entails Selecting appropriate vehicle level targets; Selecting a system architecture
For premium support please call: 800-290-4726 more ways to reach us
MacPherson strut suspension, track control arm coloured dark blue. In automotive suspension, a control arm, also known as an A-arm, is a hinged suspension link between the chassis and the suspension upright or hub that carries the wheel. In simple terms, it governs a wheel's vertical travel, allowing it to move up or down when driving over ...
The two arms, the spindle, and the body, form a four-bar link.Use of the linkage at the lower suspension connection of either a MacPherson strut or a short long arms suspension readily gives an effective virtual ball joint outboard of the spindle, which is very useful for a suspension designer, allowing negative scrub radius whilst allowing the ball joints to move in and thus out of the way of ...