Search results
Results From The WOW.Com Content Network
A threaded rod, also known as a stud, is a relatively long rod that is threaded on both ends; the thread may extend along the complete length of the rod. [1] They are designed to be used in tension. [2] Threaded rod in bar stock form is often called all-thread (ATR); other names include fully-threaded rod, redi-rod, continuously-threaded rod ...
The patient may hop on the other leg or use crutches or other devices for mobility. In this grade, 0% of the body weight may be rested on the leg. Touch-down weight-bearing or Toe-touch weight-bearing: The foot or toes may touch the floor (such as to maintain balance), but not support any weight. [3] Do not place actual weight on the affected leg.
The line of sucker rods is represented in this diagram by the solid black line in the center of the well. A sucker rod is a steel rod, typically between 7 and 9 metres (25 and 30 ft) in length, and threaded at both ends, used in the oil industry to join together the surface and downhole components of a reciprocating piston pump installed in an oil well.
A tie rod or tie bar (also known as a hanger rod if vertical) is a slender structural unit used as a tie and (in most applications) capable of carrying tensile loads only. It is any rod or bar-shaped structural member designed to prevent the separation of two parts, as in a vehicle. Tie rods and anchor plates in the ruins of Coventry Cathedral
The rods and caps would have shims that could be peeled off as the Babbitt wore down. Ford was known to use two 0.002" on each cap and Babbitt that was 86% tin, 7% copper, 7% antimony (see the KRW catalogs for the Model T). Steel shims were used, as the brass shims used today tend to compress over time, contributing to shorter bearing life. The ...
It usually is used in reference to bolted joints and bearings, but can be applied to a wide variety of engineering applications. On a screw the bearing area loosely refers to the underside of the head. [32] Strictly speaking, the bearing area refers to the area of the screw head that directly bears on the part being fastened. [33]
The typical arrangement uses a large sliding bearing block called a crosshead with the hinge between the piston and connecting rod placed outside the cylinder, requiring a seal around the piston rod. [12] In a steam locomotive, the cranks are usually mounted directly on the driving wheels. The connecting rod is used between the crank pin on the ...
A tandem axle is a group of two or more axles situated close together. Truck designs use such a configuration to provide a greater weight capacity than a single axle. Semi-trailers usually have a tandem axle at the rear. Axles are typically made from SAE grade 41xx steel or SAE grade 10xx steel.